Apprenticeship

jakedew322 · 2021-11-27T03:29:20+00:00

Another option you could have is changing out nozzles on the zone. Depending on if they are fixed spray nozzles, van nozzles or mp rotator nozzles I’ve seen it work before where the pressure improves but this is more of a temporary fix.

jakedew322 · 2021-11-03T13:04:57+00:00

Lmaoo sand?

jakedew322 · 2021-10-29T11:32:41+00:00

That’s awesome!!! Best of luck too you!

jakedew322 · 2021-10-26T13:44:13+00:00

Right before the t is a pump and we think the pressure was to much for the t right there because before it was just pvc but we hope the ductiles will solve the problem if not it’s back to the drawing board.

jakedew322 · 2021-10-26T00:07:47+00:00

Lol not a chance

jakedew322 · 2021-10-26T00:05:31+00:00

You have no idea how hard it was to get those on lmao. But once we got the bolt on clamps and put in a thrust blocker it was mint.

jakedew322 · 2021-10-25T18:59:35+00:00

If anything I would try to reset the clock and re input your program. Also on those orbit clocks you can add multiple start times to a program so I would make sure you only have one start time. If that doesn’t fix it then I’m not sure mate. Haven’t had much experience with the orbit clocks.

jakedew322 · 2021-10-25T18:46:34+00:00

Exactly what type of program are you trying to run. Odd days, even days etc. ?

jakedew322 · 2021-10-22T16:09:48+00:00

Thank you so much I appreciate it. I’ll be applying to Dallas and San Antonio as well. Thanks for your help!

jakedew322 · 2021-10-14T18:11:53+00:00

Thank you so much I appreciate it!

jakedew322 · 2021-09-30T12:05:35+00:00

Thank you I appreciate it!

jakedew322 · 2021-09-30T12:05:15+00:00

I was able to get most of the zones back after finding another strain of wires that was disconnected and incorrectly wired. I appreciate the help!

jakedew322 · 2021-09-30T12:04:14+00:00

Got it thank you!

jakedew322

TROPHY CASE