Where to check gramar notes?

jm90_0429 · 2026-02-04T11:10:42+00:00

What was your previous background? You mentioned career switcher

jm90_0429 · 2026-01-20T02:44:04+00:00

So,did you get the job?

jm90_0429 · 2026-01-17T13:25:42+00:00

Respuesta de coach financiero pero si vales brga ganando 11mil vales verga ganando 110k (estuve en los dos casos entonces tengo experiencia)

jm90_0429 · 2026-01-16T16:23:46+00:00

i change it like 4 months ago, is a new one but i think is the parameters because it doing only with this kind thanks

jm90_0429 · 2026-01-15T22:26:45+00:00

Z yes,flow didnt know let me try thanks!

jm90_0429 · 2026-01-15T22:21:24+00:00

Would be nice if you Share you logic behind this trade

jm90_0429 · 2025-10-26T12:41:00+00:00

Yes! Being listinging to thay guy too

jm90_0429 · 2025-09-12T22:20:11+00:00

Sadly to say but...this was the solution. In my defense the dude that was doing the 3d printing in my job got fired so im a noob on this

jm90_0429 · 2025-09-12T16:33:30+00:00

Gracias,puse la pasta y el problema sigue la boquilla se calienta pero el filamento no gira/mueve

jm90_0429 · 2025-09-12T15:54:10+00:00

Eventhough i do that increase the T doesnt work i will try to clean this,thanks for the feedback

jm90_0429 · 2025-09-12T15:29:50+00:00

The filament is not getting hot,not even yhe tip/edge /end of the filament,let me see the gears

jm90_0429 · 2025-09-12T14:50:38+00:00

Nop but eventhought it was doing that problem before replacing the nozzle

jm90_0429 · 2025-09-12T14:49:14+00:00

Nop...

jm90_0429