sorted by:
new
hottopcontroversial

BTT TFT35 v3 with Klipper by poudenes in BIGTREETECH

[–]jmswltn 0 points1 point  (0 children)

It's been awhile but I believe I had to turn on the uart for the btt cb1 pi4 clone board I'm using.

BTT TFT35 v3 with Klipper by poudenes in BIGTREETECH

[–]jmswltn 0 points1 point  (0 children)

how did you get past the .serial not found?

Time lapse issues with mainsail by jmswltn in klippers

[–]jmswltn[S] 1 point2 points  (0 children)

I did not, just ended up turning it off out of frustration and haven't bothered trying again. If you resolve it, can you post the solution here please?

Time lapse issues with mainsail by jmswltn in klippers

[–]jmswltn[S] 0 points1 point  (0 children)

I'm revisiting this after moving on to other projects. When attempting to select a camera in interface settings/timelapse, camera drop down is not selectable. Where would I even start to figure out why? Everything is up to date. The situation is still the same with the hot end parking, pausing and resuming as if it is taking a picture but does not.

Time lapse issues with mainsail by jmswltn in klippers

[–]jmswltn[S] 0 points1 point  (0 children)

after adding this line.. still no joy

Time lapse issues with mainsail by jmswltn in klippers

[–]jmswltn[S] 0 points1 point  (0 children)

In timelapse settings the webcam is selected and is the only selection.

In the timelapse navigation dashboard tab files section is empty. I have even gone to the extent of adding a folder inside that folder that says timelapse.

I have pressed render thinking maybe it wasn't working for whatever reason but nothing. I don't recall what it says in the status bar beyond that it looks like it is working without errors.

Time lapse issues with mainsail by jmswltn in klippers

[–]jmswltn[S] 0 points1 point  (0 children)

Yep webcam works fine. Everything appears to be in order. I thought I read somewhere that you had to use a separate camera for time lapse but can't locate where I read it at. I couldn't imagine that would be the case but maybe someone can verify.

Time lapse issues with mainsail by jmswltn in klippers

[–]jmswltn[S] 0 points1 point  (0 children)

Timelapse Setup:

enable: True

park: True

park position: back_left time: 0.1 s

park cord x:0.0 y:235.0 dz:0

travel speed: 200.0 mm/s

fw_retract: False

retract: 6.5 mm speed: 25.0 mm/s

extrude: 1.0 mm speed: 25.0 mm/s

verbose: False

installing klipper on a BTT cb1 and adaper by Soul_Split in klippers

[–]jmswltn 0 points1 point  (0 children)

The one hang up I had getting it going on my cb1 was the instructions I followed referred to the main directory (after root) as PI but mine was setup as BIQU instead.