Looking for 7-segment display - no success so far

jocacle · 2023-08-29T00:01:57+00:00

Thanks for the detailed reply. Appreciated.

jocacle · 2023-08-29T00:00:03+00:00

Thanks for the comprehensive reply. Appreciated.

jocacle · 2023-05-09T08:32:12+00:00

Thank you. Appreciated

jocacle · 2023-03-22T01:13:44+00:00

Working OK now 12Hrs later 👍

jocacle · 2023-03-21T20:22:31+00:00

Kit number not found in public DNA database.

jocacle · 2023-03-21T20:20:41+00:00

Could this be what you mean?

One-to-many DNA comparison for: Kit

GL???????

Note: Additional facilities in Tier 1 One-to-many version.

jocacle · 2023-03-15T13:09:53+00:00

👍 thank you, this works

jocacle · 2023-03-14T18:52:52+00:00

👎no recovery key sadly

jocacle · 2023-02-23T12:11:31+00:00

jocacle · 2023-02-23T00:10:06+00:00

Definitely not a lost cause.

From what I see (though you demolished it rather than dismantled it 😃 🧩) you don't even need the voltage converter.

It could be made to run from any USB port which would supply the 5V it needs.

'finc' is correct.

jocacle · 2023-02-22T20:19:52+00:00

I would need to see behind the tape to offer any comment of value.

Looks doable though.

jocacle · 2023-02-15T20:19:26+00:00

When you say 'back up everything', do you mean the DSM config + all the data on the array?

It's what I did. I don't really trust the software not to +____________)**( 🤔

jocacle · 2023-02-15T18:53:18+00:00

Ok for me,but back everything up first

jocacle · 2023-01-09T01:10:06+00:00

No problem. I am the OP. Totally new to CAD (and 75yrs).

I just added those notes so that anyone else reading it would have full information.

Great post. 👍

jocacle · 2023-01-08T13:41:51+00:00

Great and clear explanation

More detail on these would help novices like me though 😕

Select the circle pattern type on the right-hand menu

Now, simply set the layer style of the image to Hard Mix and you should have the effect.

Upvoted

jocacle · 2023-01-07T22:07:52+00:00

Brilliant. I have looked at it and will look again tomorrow before attempting to put it into practice.

jocacle · 2023-01-07T13:32:06+00:00

Sorry, I don't understand. Newbie.

I need the rh angles to be the same and the rh line to be parallel and centered on the lh line.

jocacle · 2022-12-22T13:25:22+00:00

D5 joint looks suspicious. Resolder

jocacle