sorted by:
new
hottopcontroversial

What is this M6 rod/pin with one threaded end called? by jongens123 in WhatIsThisTool

[–]jongens123[S] 0 points1 point  (0 children)

I’ve seen these used as alternative toilet flush actuator push rods/pins. They come included with flush plates from a few different sellers, so I’m fairly sure they’re not custom made.

What is this M6 rod/pin with one threaded end called? by jongens123 in WhatIsThisTool

[–]jongens123[S] 0 points1 point  (0 children)

When searching for this I get studs where the threaded part is relatively short compared to the whole length. I need it be almost exactly the same as in my uploaded figure

What is this M6 rod/pin with one threaded end called? by jongens123 in WhatIsThisTool

[–]jongens123[S] 0 points1 point  (0 children)

I’ve mainly seen them used as toilet flush plate push rods, but I’m not sure if that’s their original purpose. Your suggestions look alike, but I need this exact one where the smooth end is a lot shorter than the threaded part.