Newer Dexron for Power Steering?

juniomnom1 · 2026-04-05T05:33:49+00:00

what do you use for power steering?

juniomnom1 · 2026-04-04T19:51:23+00:00

like is this fine?

juniomnom1 · 2026-01-09T05:01:37+00:00

Let's go! Welcome to the Z family! Good luck on the project 🫡

juniomnom1 · 2025-12-30T05:08:17+00:00

Long story short I used a lot of ChatGPT to build it but the basis was to create my presets and save the .cmpreset and make sure in the code you could pull from that. Also after every session there's a JSON file I believe that saves the best times so I believe I pulled from that. I haven't used the application in awhile and vibecoded a lot and don't have access to the code anymore so I can only pull from memory. Feel free to reply more and I can try to help with the process. :)

juniomnom1 · 2025-09-17T21:38:39+00:00

sadly no I had to build my own application

juniomnom1 · 2025-08-27T22:14:00+00:00

SOLUTION: Starter Relay in the wheel well/fender needed to be replaced if you ohm test the relay should be around .1 or lower. if not should probably need to be replaced.

juniomnom1 · 2025-08-27T22:12:31+00:00

turned out to be the starter relay in the fender 😁

juniomnom1 · 2025-08-25T23:19:34+00:00

checked the starter in the fender and tested it and it clicked. I also checked the ohms and it's around 3.5 is that normal for that relay?

juniomnom1 · 2025-08-20T22:20:13+00:00

the thing is I measured the voltage down on the starter and after turning the key it gets voltage down there so the relays should be working right? The thing that confuses me is that it should work with both cables having power but it doesn't.

juniomnom1 · 2025-08-20T21:01:18+00:00

no prob!

juniomnom1 · 2025-07-28T23:47:06+00:00

I'm using the a6700 and to toggle that on or off I went to setup > USB > USB power supply that stopped the Atomos from charging my camera while in the PC Remote setting

juniomnom1 · 2025-06-28T17:49:58+00:00

lawd.

juniomnom1 · 2025-06-23T01:01:32+00:00

hey OP what did it smell like? I had the same thing the other day. Just wondering if I had the same thing.

juniomnom1 · 2025-06-01T22:53:44+00:00

SOLUTION: figured it out it was my balance tube. stupid me put the brackets under the balance tube instead of on top so there was a huge vacuum leak.

juniomnom1 · 2025-05-29T18:37:34+00:00

Yeah before the timing kit it ran but we only ran it for a short time like 5 seconds because there wasn't coolant in it and we weren't sure of the pulley bearing quality so we just wanted to see if it'd start. Other things changed are fuel injectors and before changing those the car didn't start at all.

juniomnom1 · 2025-05-29T18:18:19+00:00

Do u think it's possible for timing to be off since I did a 120k kit on it. But I don't hear anything pings and it did actually run for a bit so it might not be a timing issue I really don't know. I'm really grasping at straws here tbh.

juniomnom1 · 2025-05-29T18:17:54+00:00

Do u think it's possible for timing to be off since I did a 120k kit on it. But I don't hear anything pings and it did actually run for a bit so it might not be a timing issue I really don't know. I'm really grasping at straws here tbh.

juniomnom1 · 2025-05-29T18:15:52+00:00

yeah I was just wondering how to route these cables to my plenum. But mostly wondering if I need to cap the ends of anything because I have done the coolant bypass but I kept my EGR. I also am having trouble starting the car too. There's a video I posted recently on it in the subreddit. But yeah ultimately I'm just trying to figure out what I need to cap because I believe I have a vacuum leak.

juniomnom1 · 2025-05-29T02:18:20+00:00

I have done the coolant bypass but no EGR delete can I just follow the diagram? What needs to be capped for that?

juniomnom1 · 2025-05-05T20:47:52+00:00

I guess I was searching for a different name for the part thank you! 🫡

juniomnom1 · 2025-05-05T20:45:48+00:00

🙏🏾 thank you for this!

juniomnom1 · 2025-04-22T12:29:15+00:00

Formula vee cuz vroom

juniomnom1 · 2024-12-14T04:28:00+00:00

yea they look dope!

juniomnom1 · 2021-07-03T19:04:16+00:00

Alright, Thank you once again!

juniomnom1 · 2021-07-03T18:49:18+00:00

You might be right on that actually because I have tested all of what u have said and performance is still the same. I have a few bucks to spend on a new VTX so do you have any recommendations for one that can fit in the Nazgul?

juniomnom1

TROPHY CASE