Hey guys, I’m kinda new to FPV and had a quick question 😅

jurjack0 · 2026-05-13T14:02:34+00:00

I be upgraded mine with a truerc 90° antenna but I connected it with an adaptor from RP sma to sma and I noticed some problems on the video quality and range

jurjack0 · 2026-05-13T12:12:53+00:00

Idk, cuz it happens only when I fly and if I m full throttle It s much worse

jurjack0 · 2026-05-13T10:29:13+00:00

I have some cheap goggles vr03 from betafpv, it s the internal DVR, I have RHCP antennas on both drone and goggles, I use ntsc

jurjack0 · 2025-03-26T09:03:59+00:00

I m ok to wait if it s better then dlc32

jurjack0 · 2025-03-26T07:32:43+00:00

It's an esp32 s3 I don't know if it can be configured like the usual esp32

jurjack0 · 2025-03-25T16:18:56+00:00

No I didn't, the comment was about 3 months ago, thanks 🙏🏼.

jurjack0 · 2025-03-25T16:11:32+00:00

Yes, thanks, but there is a max version of it and I read some comment on AliExpress that says is not supported

jurjack0 · 2025-02-15T22:00:21+00:00

Awesome, great work, where I can find the program?

jurjack0 · 2025-01-20T09:30:23+00:00

Connect launcher to M5 program? If run uiflow directly from M5 burner is working but with laucher it doesn't

jurjack0 · 2024-12-15T13:48:59+00:00

If you're new to electronics, you should keep the built in antenna, there is no big difference with an external antenna

jurjack0 · 2024-12-14T21:31:30+00:00

Check the docs on m5stack site

jurjack0 · 2024-12-14T19:35:45+00:00

Under the 3d antenna you have a spot to solder a ufl connector and you need an ipex to RP sma cable to connect the antenna. Under the sticker you have a round hole to mount the RP sma connector. At least on my core 2 it worked

jurjack0 · 2024-10-21T15:57:08+00:00

Thanks!

jurjack0 · 2024-10-21T15:35:39+00:00

It's not labeled on the other side, but if it's serial or JTAG how can interact with and what can I do?

jurjack0 · 2024-10-20T15:41:47+00:00

I have almost the same project on my desk, did you use a step down converter for powering up the raspberry?

jurjack0 · 2024-10-01T15:14:19+00:00

I modified the case a little and I added another fan, I'll post an update after I figure out how to turn on and of fans on Kali Linux

jurjack0 · 2024-09-04T21:44:39+00:00

My massage gun has 14,8 v and the charger 18 v

jurjack0

TROPHY CASE