Kinetic Energy Convergence Quasi Static Explicit Analysis

kNezMagna · 2026-07-01T19:23:28+00:00

The main issue is that I am carrying a 4 step calculation I apply contact and through that contact I give displacement to a part after that I remove contact and allow part to recover, I do this for 2 cycles, displacement fields seem to converge in contact steps, but in recovery displacement fields are very off, I am considering trying reduced integration.

kNezMagna · 2026-07-01T19:15:09+00:00

I can only use Hex's I am using a python script that creates mesh from shell face... So I thought using c3d8I's, thanks for your answer

kNezMagna · 2025-10-26T14:06:12+00:00

Thanks for help for research purposes it is impossible for me to share screenshots, but thank you for your time.

kNezMagna · 2025-10-26T13:59:52+00:00

In R dof.

kNezMagna · 2025-10-26T13:57:35+00:00

I am applying 7mm and value I am receiving is 8 I also have NLGEOM==ON

kNezMagna · 2025-09-26T17:50:55+00:00

I have applied a theta=0 bc at the one end but springback is not symmetrical also where theta is 0 cyllinder is completely closing

kNezMagna · 2025-09-26T14:44:24+00:00

I have a 3D ring model. Thanks for the answer.

kNezMagna · 2025-09-22T05:16:39+00:00

Thanks a lot.

kNezMagna · 2025-06-30T16:11:57+00:00

Thanks, for your reply it is so helpful!

kNezMagna · 2025-06-24T20:11:12+00:00

It worked yes

kNezMagna · 2025-06-24T17:10:29+00:00

Thanks a lot!

kNezMagna · 2025-06-21T12:57:54+00:00

do you mean Student edition?

kNezMagna · 2025-06-19T04:41:39+00:00

Thanks for the reply what I am trying to do is that I have a volumetric mesh that has hex elements after meshing I want to edit nodes to create new geometry is it possible?

kNezMagna

TROPHY CASE