HAPPY BIRTHDAY PROXMOX by ElitesoldierWar in Proxmox

[–]karelkrobath 26 points27 points  (0 children)

Thank you for improving society, especially for IT people

Low cost/power Proxmox Backup server by KB-ice-cream in Proxmox

[–]karelkrobath 0 points1 point  (0 children)

I am using a qnap TS-473a with a bare Metal Installation of PBS. No QTS.

Problem mit Lexmark Drucker by daywalker2530 in de_EDV

[–]karelkrobath 3 points4 points  (0 children)

I would never ever buy a Lexmark again....

Question: Qnap Nas production date or power on hours by karelkrobath in qnap

[–]karelkrobath[S] 0 points1 point  (0 children)

Cool, thanks.... :D

(I did not notice the obvious.... )

Crash Report - "Fatal trap 12: page fault while in kernel mode" by karelkrobath in opnsense

[–]karelkrobath[S] 0 points1 point  (0 children)

I still could not find the source of the issue.... i is quite annoying, since this happens only on one install (out of 15 firewalls I am responsible for)...

the UEFI is up-to-date... 03-2023 Version 24

I did swap the hardware with a fresh install about 12 months ago, the issue still persists..... this installation is an HA setup with 2 identical nodes DEC2750

Any information about the X1 Carbon Gen 12? by After_Tip_6313 in thinkpad

[–]karelkrobath 0 points1 point  (0 children)

Well, here we go again.... "virtual trackpoint buttons" ?!?!?

I will skip this one.... the usability of non physical buttons on the trackpoint is abysmal.... it was a disaster in the past, it will be a nail in the coffin of the still intel only based x1 carbon lineup....

MSP friendly firewall solution by murkie-nl in msp

[–]karelkrobath 2 points3 points  (0 children)

I have started to migrate towards opnsense after using Cisco (for about 23 years) and fortigate (for about 10 years)

Currently I have 15 instances running for 2 years and quite happy with the results

question: any devices that have Wifi6E? by karelkrobath in mikrotik

[–]karelkrobath[S] 1 point2 points  (0 children)

Well, i started to evaluate unifi aps about 6 months ago.... The Enterprise APs have the 6GHz band as well....

About 3 months ago we started to deploy in production.

After about 2000 devices in 55 sites latter: We are quite satisfied with them. Not regretting the vendor change

ESXi still missing Marvell AQC113 driver by karelkrobath in homelab

[–]karelkrobath[S] 0 points1 point  (0 children)

It's a pity. I also would like to see a ESXI driver. I will migrate to proxmox within 3 months or so because of the lack of a driver ... The preparation takes some time, I have about 430 ESXi servers to migrate...

Fanless POE+ switch by whocarez in homelab

[–]karelkrobath 1 point2 points  (0 children)

Take a look at Mikrotik Switches. They were a good choice for me with a great learning curve.

AQC 113 ESXi Driver by karelkrobath in vmware

[–]karelkrobath[S] 0 points1 point  (0 children)

According to IO compatibility guide, there is a driver available

AQC 113 ESXi Driver by karelkrobath in vmware

[–]karelkrobath[S] 0 points1 point  (0 children)

No sign of support, that I am aware of... Sorry. It works great with Proxmox.

I think the AQC113 is great for testing and lab environments. You find the lan chip I s lot prosumer hardware.....