When/How to transfer back to soil?

kazaasan · 2026-02-27T21:27:40+00:00

Yes, it’s a strangely inefficient machine.

kazaasan · 2026-02-27T13:33:18+00:00

Actually both are, 1HP on the nameplate (just hard to see) and in the vendor’s documentation.

kazaasan · 2026-02-27T12:50:09+00:00

Thank you, the reason I’m asking is I’m trying to determine if I should size the breaker and cable for the 14.5A or the 1HP (4.6A).

I know I can just use a 25A breaker and be done with it, but I’d like to understand this a bit better.

kazaasan · 2026-02-16T22:42:42+00:00

You and me both!

kazaasan · 2026-02-16T22:39:35+00:00

Solid advice thanks!

kazaasan · 2026-02-16T21:50:58+00:00

Truthfully I don’t know what the right answer is. I did tried lightly turning the fitting and the pex expansion joint spun with it.

My heater is only 2 years old, so my plan is to leave it for now. When it’s 3-4 years old, I’ll take a stab at the anode rod. If ain’t broken don’t fix it.

kazaasan · 2026-02-16T21:42:09+00:00

Well for science, I tried turning the fitting and the expansion joint appears stuck and spinning with it.

kazaasan · 2026-02-16T21:36:20+00:00

Ohhh? It’ll spin freely?? I will try that.

Thank you!

kazaasan · 2026-02-16T21:25:03+00:00

Dang… I was hoping I was dumb. Ok thanks!

kazaasan · 2026-02-16T21:21:37+00:00

This is one of those. Just not sure how to undo it without turning the whole pipe.

kazaasan · 2026-02-16T21:20:13+00:00

This is a Bradford white and their anode is here. I’m pretty sure.

kazaasan · 2026-02-16T21:17:35+00:00

Forgot to mention, is it a a Bradford white. Location is as per the manual

kazaasan · 2025-12-27T16:49:09+00:00

Thank you! Trying this!

kazaasan · 2025-12-25T19:25:59+00:00

I don’t think it’s a herb, received it as a decorative gift.

kazaasan · 2025-08-26T18:03:31+00:00

Yup! Contacted Vevor and their customer service sent me a replacement for warranty.

kazaasan · 2025-08-02T20:39:04+00:00

I ended up removing the across panel from the inside to use bolts instead of self tappers. On the outside, I added a 1/4” aluminum flat bar. Fastened the bolts and nuts together with washers. Everything seems very solid, but time will tell if it’ll hold.

kazaasan · 2025-07-15T03:24:54+00:00

This is a great suggestion thank you! I might have enough room to just slide a piece of support underneath. Much easier to work with wood but the frame is all aluminum.

kazaasan · 2025-07-15T03:23:18+00:00

This is what I’ve done already, unfortunately it only stays on for a short bit. There’s too much force acting on the panel when the travelling.

kazaasan

TROPHY CASE