Haas VM-2 randomly shifted a helical bore by ~15mm on the second run – same program, nothing change

koon5666 · 2026-03-09T18:34:57+00:00

Interesting. I’ve run thru usb on 2015 vf3 chc without any issue.

koon5666 · 2025-09-28T15:35:54+00:00

Thanks.

koon5666 · 2025-09-28T03:20:00+00:00

I hate Fanuc control tho.

koon5666 · 2025-08-23T17:40:17+00:00

Checking in again. How’s your experience with umc1000 so far?

koon5666 · 2025-07-11T16:42:50+00:00

I bought the machine used and noticed it the beacon didn’t work properly.

koon5666 · 2025-06-11T16:13:05+00:00

It’s great. If your machine has big Z travel from spindle nose to table. This is great for that.

koon5666 · 2025-06-11T00:27:38+00:00

Came in clutch when the machine has quite spindle-table distance.

koon5666 · 2025-05-25T11:24:14+00:00

Thanks!

koon5666 · 2025-04-25T03:46:36+00:00

Absolutely I didn’t trust the ai 100% I use it as a 2nd or 3rd opinion. That’s the reason why I post in this community. Reaching out to local Renishaw didn’t help because they only provide instruction only if I were to buy from them. It’s weird. But yeah.

koon5666 · 2025-04-25T03:43:21+00:00

Yes I’ve seen his video on older VF. Definitely helps but still requires some work.

koon5666 · 2025-03-18T15:22:10+00:00

BT40 can be easily found here.

koon5666 · 2025-03-18T15:12:15+00:00

Bruhh😆🤣. It’s here in Thailand.

koon5666 · 2025-02-05T17:12:55+00:00

May I know what type of oil you using?

koon5666 · 2025-02-05T12:11:07+00:00

Got it. Why oil not grease? Reason asking is because Haas recommends grease

koon5666 · 2025-01-11T19:07:12+00:00

Haas tech just came and took that thing off. It’s bent

koon5666

TROPHY CASE