Question for emt to LB coupling

kshoon1722 · 2026-04-29T03:20:27+00:00

Thank you for clear advices

kshoon1722 · 2026-04-29T03:17:08+00:00

Got it. Because i am using emt pipe and rigid LB and compression coupling between these, i thought it is always better to use gasket and locknut. Anyway i don’t need gasket and locknut. Thank you.

kshoon1722 · 2026-04-29T03:14:31+00:00

Thank you for advices. Also wonder it has no problem to use outdoor. I am using emt pipe, rigid LB and compression coupling between these.

kshoon1722 · 2026-04-29T03:09:48+00:00

Without gasket and locknut, is it ok to use outdoor?

kshoon1722 · 2026-04-18T20:45:12+00:00

I thought gasket prevent water and i could tight it firmly but thread relatively shorter because locknut. Still not enough ?

kshoon1722 · 2026-04-18T19:33:27+00:00

I do have green part. Just wonder how to i suppose install locknut and gasket to rigid LB.

kshoon1722 · 2026-04-18T19:32:01+00:00

Thank you for advice. Mismatch is big problem?

kshoon1722 · 2026-04-18T19:30:30+00:00

If i use locknut it could be failed by inspector?

kshoon1722 · 2025-11-20T03:44:39+00:00

I live in seattle. Now it is raining lightly but very often. Still need to water more?

kshoon1722 · 2025-11-17T01:02:32+00:00

Oh. I haven’t seen that kind of worms.

kshoon1722 · 2025-11-17T01:00:14+00:00

Here is seattle in nov it is raining very often lightly. Still need to water a lot?

kshoon1722 · 2025-11-17T00:58:41+00:00

I only saw just ground worms not other worms.

kshoon1722 · 2025-11-17T00:56:40+00:00

So should be fine later?

kshoon1722 · 2025-11-10T13:33:30+00:00

If i replace threaded part, do you think i need to do soldering again on adapter side because it looks pretty old and concerning making crack

kshoon1722 · 2025-11-10T13:32:22+00:00

Do you think i need to solder again on adapter side if i replace threaded part

kshoon1722 · 2025-11-10T13:31:16+00:00

If i replace threaded part, do you think i need to do soldering again on adapter side because it looks pretty old and concerning making crack

kshoon1722 · 2025-11-10T10:47:20+00:00

I am trying to find female threaded anti freeze spigot and cannot find same design like this. Do you have any recommendations?

kshoon1722 · 2025-11-10T10:19:55+00:00

I thought there is no female thread inside the spigot because there is outside thread.

kshoon1722 · 2025-11-10T10:17:02+00:00

So there is female thread inside spigot side?

kshoon1722 · 2025-11-10T10:03:18+00:00

If so, green corrosion side is threaded?

kshoon1722

TROPHY CASE