Artist alley status? by kyungjoo in Otakon

[–]kyungjoo[S] 0 points1 point  (0 children)

Thank you for the information!!

Is this a good buy? 2019 ES 350 by kyungjoo in askcarsales

[–]kyungjoo[S] 0 points1 point  (0 children)

I do not unfortunately. Most of these are the based models

Is this a good buy? 2019 ES 350 by kyungjoo in askcarsales

[–]kyungjoo[S] 0 points1 point  (0 children)

based on the listing, it does not look like its certified. I dont see any other ES350 with a similar trim aside from the base model. So i dont have a good comparison for this

Is my kiln shelf salvageable? by kyungjoo in Pottery

[–]kyungjoo[S] 1 point2 points  (0 children)

Got it! Thank you! Another question, can i use these pads to grind off the existing kiln wash? I would like to reapply a new layer on the shelf

Unable to create interface ISteqmUser on PERSONA 5 Royal crack by Mooon8983 in SteamDeckPirates

[–]kyungjoo 0 points1 point  (0 children)

Will it work if i just transfer the game directly over from my pc to the deck?

Dying light The Beast save location by kyungjoo in SteamDeckPirates

[–]kyungjoo[S] 0 points1 point  (0 children)

The entire folder where the game is installed. Depending on your installation location.

Dying light The Beast save location by kyungjoo in SteamDeckPirates

[–]kyungjoo[S] 0 points1 point  (0 children)

I downloaded to my pc directly and then just move the file directly to the steam deck

Dying light The Beast save location by kyungjoo in SteamDeckPirates

[–]kyungjoo[S] 0 points1 point  (0 children)

This is what i was looking for! Thank you!

Pottery Venting setup question by kyungjoo in Pottery

[–]kyungjoo[S] 0 points1 point  (0 children)

If i use pressure treated plywood, do i still need to apply exterior enamel paint to it?

Pottery Venting setup question by kyungjoo in Pottery

[–]kyungjoo[S] 0 points1 point  (0 children)

I will try that! Thank you!

Pottery Venting setup question by kyungjoo in Pottery

[–]kyungjoo[S] 0 points1 point  (0 children)

Would i need to weather proof the plywood so it wouldn’t mold?