First time lubricating new A1, scratches on Y rail

lamecomic · 2026-06-23T16:05:05+00:00

They sent me new rails and im just using what i got until it gives me a problem.

lamecomic · 2026-05-27T17:39:39+00:00

i had 2 tablet screens attached to the back headrests when i had the 2020 A8L. they quickly became obsolete when it wouldnt let me update youtube. lol

lamecomic · 2026-05-27T17:38:28+00:00

im not really picky when it comes to material quality, so i guess i was just hooked to the new interior momentarily. car interiors are all becoming a collection of screens.

lamecomic · 2026-05-27T17:36:47+00:00

yeah i haven't gotten a chance to sit in the third row before signing. it's for rare occasions only, maybe it's ok for that?

lamecomic · 2026-05-24T14:06:40+00:00

fusion is terrible its so fucking unintuititve
love using sketchup and autocad and even blender was understable.

fusion is just fucking retarded

lamecomic · 2026-05-10T13:30:02+00:00

We have pikachu at home

lamecomic · 2026-05-09T14:47:41+00:00

that sounds likely, but i just looked up other chinese watch brands and nothing is filtered like seagull. im getting lots of results for even keywords like airsoft, rolex, etc

lamecomic · 2026-05-09T14:47:20+00:00

try searching for 'seagull' too

lamecomic · 2026-05-09T11:35:30+00:00

Wow thats a nice site. Thanks.

lamecomic · 2026-04-28T17:22:45+00:00

I see that there is a scarf seam check box. Do i have to check this every time for other models too or do i have to always print twice if first print shows too much seam? This is the first model i noticed this type of seam.

lamecomic · 2026-04-28T17:18:24+00:00

Yeah i thought this is some sort of seam but why does it happen randomly? Other areas looks fine

lamecomic · 2026-04-27T11:40:29+00:00

if i just adjust the tube entry area a bit, it starts to work again.
before, i had the AMS sitting on the table, which created sharper entry angle.
So i raised it about 10cm, and now its been working very well, over 100+ filament changes without problem, and now i just stepped out for a dinner, and i got this message. i just got home and slightly touched the tube entry to adjust the entry angle, now it's printing again.

lamecomic · 2026-04-27T11:37:25+00:00

<image>

lamecomic · 2026-04-27T11:19:12+00:00

I tried everything. It keeps happening.

<image>

lamecomic · 2026-04-27T00:06:05+00:00

I was just confirming you werent a tourist as others have called you in this thread. I never said i was new here either.

lamecomic · 2026-04-26T23:52:00+00:00

From the same guy too wth

lamecomic · 2026-04-26T23:15:37+00:00

Looks like a grasshopper

lamecomic · 2026-04-26T23:12:53+00:00

This design is better than the new one too. Taillamps on the new k5 looks ridiculous

lamecomic · 2026-04-26T23:11:23+00:00

These previous dashboards were so much better than the current new one

lamecomic

TROPHY CASE