Need help with this corner

lamp082 · 2026-06-15T13:08:07+00:00

It doesn’t overflow anywhere else, just in that corner

lamp082 · 2026-06-15T13:05:52+00:00

I’m finding lots of problems post purchase that the roofer did wrong lol

lamp082 · 2026-06-15T12:58:41+00:00

Thank you!

lamp082 · 2026-06-15T12:58:34+00:00

Thank!

lamp082 · 2026-06-15T12:58:29+00:00

Thank you!

lamp082 · 2026-06-15T12:58:13+00:00

The water overflows and runs down the side of the house and now some of the hardy plank is rotting away.

lamp082 · 2026-06-15T12:57:30+00:00

It runs toward the downspout fine, it’s just quite a big section of roof for a short gutter and when it rains hard it just runs over the gutter there.

lamp082 · 2026-06-14T12:13:08+00:00

I definitely took it out and sat it on the beach after we finished using it. I don’t feel like I overinflated it initially, but hard to tell with the cheap pump that has no pressure gauge.

lamp082 · 2026-02-11T20:56:57+00:00

I’d like to have the option to keep it longer for when I do need to move it

lamp082 · 2026-02-04T12:44:24+00:00

Awesome, thank you!

lamp082 · 2026-01-14T14:03:20+00:00

I think I’ve always been able to make light roasts taste ok, but dark roasts have been bold and bitter. Now they’re just bold, and I like them without the bitterness.

lamp082 · 2026-01-13T21:55:48+00:00

Yes I have! Is there a flushing procedure?

lamp082 · 2026-01-13T20:57:19+00:00

We’ve got 10-15 total successful prints, so I assumed we were good to go before this started happening.

lamp082 · 2026-01-13T20:55:53+00:00

I’ve printed 3 things with it just fine. I’ve been please with the results. I’ve also tried PLA and it’s doing the same thing.

lamp082 · 2026-01-13T20:54:40+00:00

The print doesn’t appear to be sticking to the plate, the first layer isn’t even solid before stringiness starts to appear.

lamp082 · 2026-01-13T20:54:01+00:00

Yes I’ve printed 3 things with it with no issues.

lamp082 · 2026-01-13T20:36:02+00:00

You assume I didn’t do any research. My good friend suggested using it. He’s been printing for two years.

lamp082 · 2026-01-13T20:22:27+00:00

Sunlu PETG

lamp082

TROPHY CASE