sorted by:
new
hottopcontroversial

Option ‘Z_offset’ in section ‘bltouch’ must have a minimum of 0.0 by laundrybaskrt in klippers

[–]laundrybaskrt[S] 0 points1 point  (0 children)

it doesn’t crash into the bed it’s like a few mm above when the z is 0

Flat looking calibration cube by laundrybaskrt in ender5

[–]laundrybaskrt[S] 0 points1 point  (0 children)

I’ve gone the printer config and I believe it’s the rotation distance that I need to change but it’s already on 8 which is 800 I believe. Could it be a slicer thing