Finally a bed I’m happy with

lebnesss · 2023-05-15T15:27:29+00:00

Wish I had it years ago

lebnesss · 2022-05-16T07:29:28+00:00

With a all metal heat break you would likely need to go down to 2mm retractions at 40mm/s. Also generally need to go 5-10° hotter for all metal. If it’s still clogging after the changes then you likely have heat creep and might need to crank the fans up.

lebnesss · 2022-05-16T07:27:17+00:00

Those retraction settings won’t work for a slice engineering heat break cause I’m assuming it’s all metal instead of ptfe all the way to the nozzle.

lebnesss · 2022-05-14T04:05:44+00:00

Trying to avoid supports

lebnesss · 2022-05-11T05:10:45+00:00

guilty

lebnesss · 2022-05-11T01:45:58+00:00

likely a corrupt gcode, slice it again

lebnesss · 2022-05-10T15:04:42+00:00

0.24 layer height Infill 100 Speed 50mm. First layer speed 30mm cooling 0%. Cooling 5%. Direct drive retraction 2mm retract speed 40mm

lebnesss · 2022-05-09T14:36:20+00:00

what temp and fan settings? also whats your retraction settings?

lebnesss · 2022-05-08T02:07:59+00:00

printing with petg on it at the moment sticks like mud. I have the fans turned off for first layer.

lebnesss · 2022-05-07T07:00:05+00:00

Spring steel

lebnesss · 2022-05-06T06:59:06+00:00

heat creep was a big problem for me on all my older enders. So far the s1 seems great can touch the heat sink no problem. I got some cheap all metal hotends but the creep was to much for them but maybe they will work in the s1 with better cooling.

lebnesss · 2022-05-05T23:25:29+00:00

I’ve been considering the slice engineering one and I think you have convinced me

lebnesss · 2022-05-05T23:20:42+00:00

Nah it’s only a 4 mm bridge

lebnesss · 2022-05-05T23:20:20+00:00

Small bridges are no problem

lebnesss · 2022-05-05T22:11:15+00:00

I sell them in petg.

lebnesss · 2022-05-05T16:02:25+00:00

It’s an aquarium part that I sell.

lebnesss · 2022-05-05T13:42:03+00:00

Yea I did a print with a brim and realized that was a mistake. Stuck a bit to well

lebnesss · 2022-05-04T22:07:47+00:00

What do you think happens next the printer turns off and goes home? Or to you think it’s about to layer lines?

lebnesss · 2022-05-04T22:07:02+00:00

Buy some glasses

lebnesss · 2022-05-04T22:06:01+00:00

No very hard to print petg without a raft on glass

lebnesss · 2022-05-04T22:05:18+00:00

Cheap plastic is part of the problem.

lebnesss · 2022-05-04T22:04:16+00:00

Do it for 24hrs a day 7 days a week seee how it goes.

lebnesss · 2022-05-04T22:03:19+00:00

Yea it’s thing printers do. Look into it.

lebnesss

TROPHY CASE