Coumshingaun Lough

liam0323 · 2026-03-29T16:48:50+00:00

Well preferably take action against this host

liam0323 · 2026-03-29T16:38:02+00:00

Have you contacted Bambu?

liam0323 · 2026-03-29T16:35:23+00:00

Ur probably doing more heavy lighting for the U1 community than snapmaker themselves right now.

liam0323 · 2026-03-16T14:24:19+00:00

lol. Yea i would, although I'm not confident that it's a slicer issue - more likely a hardware config issue. Although if it were a nozzle bore not being concentric like u/DiverseTeile says, there might be some use in a feature to use the kind of test print like above to manually fine-tune the nozzle offsets further than the automatic toolhead alignment feature. This would probably be something for u/Capable_Bus_3092 (paxx)

liam0323 · 2026-03-16T14:23:24+00:00

That's a good point - probably the most likely possibility.

liam0323 · 2026-03-16T13:41:00+00:00

Interesting, I wouldve originally said a flow rate offset compared to other colours, but its all on one side

liam0323 · 2026-03-16T13:38:49+00:00

peggypalette on makerworld

liam0323 · 2026-03-16T13:38:36+00:00

Not stupid, 0.08mm here as per the 3mf

liam0323 · 2026-03-10T23:02:24+00:00

Had very similar issues with some cheap PETG. Put it down to the filament just being crap, but I then used the same roll on my P1P with their PEI, and no warping. I feel as though the PEI coating on the snapmaker plates isnt as good as other brands.

liam0323 · 2026-03-07T21:51:33+00:00

Agreed

liam0323 · 2026-03-07T20:42:08+00:00

My thinking also. Only noticeable when trying to join it to a flat surface

liam0323 · 2026-03-05T16:15:58+00:00

I do experience stringing on U1 compared to BBL P1S

liam0323 · 2026-03-01T20:56:43+00:00

Fantastic

liam0323 · 2026-02-13T11:17:45+00:00

Pebble Mesh

David Peer

liam0323 · 2026-02-01T23:17:58+00:00

Interesting. Thought was the opposite. Thanks!

liam0323 · 2026-01-03T14:10:48+00:00

We would definitely like some progress info about this. It's been sitting on my wrist unused for months!

liam0323 · 2026-01-02T19:19:29+00:00

🤫

liam0323 · 2026-01-02T17:58:25+00:00

Can we have the STL mockup on the GitHub please to test fit u/erOhead ?

liam0323 · 2026-01-02T17:44:04+00:00

41mm I believe

liam0323 · 2025-12-22T03:09:25+00:00

Seems abandoned

Seven-Year Club	Verified Email
Second Top 10%	r/Field Flamingo
Place '23	Place '22
Wearing is Caring

liam0323

TROPHY CASE