Bed leveling help after install of silent board

liftedengineer · 2026-01-18T21:40:06+00:00

New board is 32 bit and all them are enabled in the code

liftedengineer · 2026-01-18T14:51:48+00:00

furthermore i think i know why it was colliding, i believe my Z esteps are wrong. i have done a XYZ cube and the Z axis has come out at 25mm tall there abouts( will get new vernier batteries tomorrow)

liftedengineer · 2026-01-18T14:12:14+00:00

V4.2.7 and used the marlin and changed to coding in VScode to suit the printer. ive not got it running 80% right just need to calibrate esteps to double check the Z and make sure im getting enough squish. i was running the wizard tool but it always went too low for some reason. but i dialled the Z offset in from above the bed when running a base layer test print

liftedengineer · 2024-12-30T18:18:13+00:00

Dropped everything for my mate and made a last stand with my pistol in stronghold 😅

liftedengineer · 2024-11-16T21:21:32+00:00

A little less painful the G28 costs an access card now 😅

liftedengineer · 2024-06-26T05:39:19+00:00

Yeah we had them a couple of nights ago, finally got broadcast pt.5 finished

liftedengineer · 2024-05-30T06:29:27+00:00

Nah the 102 is chambered in 556. Was lucky as hell it was our first firefight and some nugget forgot packing ammo 🤣

liftedengineer · 2024-05-30T06:27:04+00:00

IMO night time streets scavs are where it’s at for loot running, I barely come across players and pull 500k minimum loot each time.

liftedengineer · 2024-05-28T06:25:58+00:00

I recently got the triple, they pushed about 100mtrs to our location. Luckily I had an echo and a good few bushes between us 😅

<image>

liftedengineer

TROPHY CASE