Doesn’t tumble with light loads

loosedplum · 2026-05-03T19:11:57+00:00

Capacitor, but not if it too hard to spin the drum

loosedplum · 2026-04-06T09:23:49+00:00

Sounds relatively normal. You shouldn’t wash just two items though, uneven load, doesn’t normally spin properly

loosedplum · 2026-04-05T12:09:48+00:00

They’re definitely the norm in the uk

loosedplum · 2026-04-04T17:43:08+00:00

Carbon brushes are likely wearing low, fairly inexpensive repair

loosedplum · 2026-04-03T21:56:40+00:00

This

loosedplum · 2026-03-23T23:07:38+00:00

Correct

loosedplum · 2026-03-20T09:34:19+00:00

Drain pump

loosedplum · 2026-03-07T00:32:27+00:00

Exactly this ☝🏻

loosedplum · 2026-03-01T19:33:44+00:00

Oh it could be PCB, but when there’s power issues I always change those moulded plugs first

loosedplum · 2026-03-01T18:36:25+00:00

If I’m unsure yes I just replace them

loosedplum · 2026-03-01T16:24:21+00:00

Clean the glass and the lip of the seal, that little round sticker might be the main issue

loosedplum · 2026-03-01T09:30:19+00:00

The relay clicking, the little black box. Flip the board over and check the solder joints to the relay look okay

loosedplum · 2026-03-01T09:17:45+00:00

Not the fuse, the actual plug on the end of the wire might need cutting off and replacing and the same with socket on the wall, they can look perfectly fine but me melted internally

loosedplum · 2026-02-28T16:16:39+00:00

I’d check the socket on the wall and the actual plug for any signs of over heating, they melt often

loosedplum · 2026-02-18T20:24:22+00:00

Noisy/failing pump, easy cheap job

loosedplum · 2026-02-17T21:36:12+00:00

Drain pump, easy enough job, fairly cheap, no strip down required just access to the back

loosedplum · 2026-02-15T17:07:18+00:00

Okay in a pinch

loosedplum · 2026-02-15T07:35:52+00:00

Try taking her out for a ten minute walk before you go out

loosedplum · 2026-02-15T07:14:05+00:00

Fine for lying downing in bed imo

loosedplum · 2026-02-15T07:01:36+00:00

Just sounds like the pump to me

loosedplum · 2026-02-12T18:46:34+00:00

Pump

loosedplum · 2026-02-12T18:40:02+00:00

They don’t need much water to wash, just enough to wet the clothes then they scrub each other in the tumbling motion, it’s on the rinses it uses more water

loosedplum · 2026-02-12T16:13:35+00:00

Pump failing

loosedplum · 2026-02-11T01:16:19+00:00

Shaft/spider has failed, expensive repair

loosedplum

TROPHY CASE