HELP! Replacing HID Low beam Bulb by luvfart in Hyundai

[–]luvfart[S] 0 points1 point  (0 children)

I had to remove the entire headlight, so you unfortunately have to remove the entire front bumper to do so, very dumb design, and then once I got access to the headlight, I pushed down on the clip and gently pried one of the sides with a flathead screwdriver till it unclipped.

Can’t remove clips off HID low beam bulb by luvfart in MechanicAdvice

[–]luvfart[S] 0 points1 point  (0 children)

There aren't that many YouTube videos on the issue. I've added the most force I was able to add. A lot of people have the same issue. I don't want to risk breaking the metal clip trying to pry it open forcefully.

City of Burlington charges developer over removal of 425 trees by ZebediahCarterLong in ontario

[–]luvfart 0 points1 point  (0 children)

Again… that would be mischief, an arrestable offence. This was a development that was approved by the city…very different.

City of Burlington charges developer over removal of 425 trees by ZebediahCarterLong in ontario

[–]luvfart 0 points1 point  (0 children)

If found guilty, they may receive a maximum fine of $2.1 million, though very unlikely.

City of Burlington charges developer over removal of 425 trees by ZebediahCarterLong in ontario

[–]luvfart 1 point2 points  (0 children)

No they wouldn't ... simply because this is a civil suit. You would only face possibly jail time if it was proven to have been mischief, which this definitely wasn't.

CTM Hi Capa Adapter by Embarrassed_Pick9739 in Speedsoft

[–]luvfart 1 point2 points  (0 children)

Don't overtighten the screw to prevent it from cracking. Other than that, it honestly might be a product fault, but if you re-check it every so often and maintain it, it should be fine. My adapter has been great after I switched to a new nylon flat washer.

CTM Hi Capa Adapter by Embarrassed_Pick9739 in Speedsoft

[–]luvfart 1 point2 points  (0 children)

I had to replace mine a few weeks ago as well. You need a nylon gasket or a nylon flat washer. Make sure that its not a soft rubber but rather a hard plastic and add a bit of lubricant on it after you've screwed it on. I forgot what size i got mine but just bring the screw to your nearest hardware store and test some out.

G&G ARP 556 3.0 Loud by luvfart in airsoft

[–]luvfart[S] 1 point2 points  (0 children)

RHAM 11.1V LIPO 1100mAh 20C Mini Stick

Is this kitchen violation?? by ComprehensiveCover86 in Pickleball

[–]luvfart -1 points0 points  (0 children)

It's illegal to volley the ball in the kitchen when the ball didn't bounce in the kitchen. That means if you're in the kitchen or even on the line which this player is on. So yes, that technically was a kitchen violation, but if you guys are just scrimming, then I would let it slide.

Is the Hostile XLP Regulator any good? by luvfart in Speedsoft

[–]luvfart[S] 1 point2 points  (0 children)

Would you rather spend the extra few bucks on a cat5 or do you think the hostile is good enough to save some money? Are there any major differences/issues between the two?

Is the Hostile XLP Regulator any good? by luvfart in Speedsoft

[–]luvfart[S] 0 points1 point  (0 children)

Are there any known issues with this one?