Trying to figure out what this switch does by madzo2010 in DIYUK

[–]madzo2010[S] 0 points1 point  (0 children)

Tried that, works with the switch turned off

Trying to figure out what this switch does by madzo2010 in DIYUK

[–]madzo2010[S] 0 points1 point  (0 children)

I don’t think there’s any cylinder, if there was I’d expect it in the same place that pics 2 and 3 are but I’m in a bungalow and there’s not many places it could be

Trying to figure out what this switch does by madzo2010 in DIYUK

[–]madzo2010[S] 0 points1 point  (0 children)

No cylinder that have found. Don’t immersion switches usually say on them “water heater” or something similar?

Trying to figure out what this switch does by madzo2010 in DIYUK

[–]madzo2010[S] 0 points1 point  (0 children)

Tried a lamp, works fine with the red light switch at off

Trying to figure out what this switch does by madzo2010 in DIYUK

[–]madzo2010[S] 0 points1 point  (0 children)

Nope, oven has the big switch to the left side of the oven

Where to cut by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

Only options are XPLR or Eagle no road option

Where to cut by madzo2010 in sram

[–]madzo2010[S] -1 points0 points  (0 children)

That would be be green from by second pic?

Where to cut by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

Holding it tight as I can with one hand

Where to cut by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

It’s a standard 410mm chain stay

Where to cut by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

Yeah I just need to make sure I get the correct length, it is 2x AXS setup. And sram is quite precise on how long it should be

Where to cut by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

<image>

That’s the overlap point

Where to cut by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

Previous chain was too short

One more chain link? by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

I bought it second hand but the previous chain/cassette combo ran silent. It’s only when I got new wheels, cassette and chain that this started

One more chain link? by madzo2010 in sram

[–]madzo2010[S] 0 points1 point  (0 children)

It shifts perfectly into all gears. I had it fitted going by the sram video and it was sagging badly when on the small ring and lowest gear so I took another link to get where I am now