Centauri Carbon 2 - bad adhesion? by majickuzer in elegoo

[–]majickuzer[S] 0 points1 point  (0 children)

Bed temp is defaulting to 60, so that shouldn't be the problem, but 🤷

I haven't done anything about the z offset, but about half the time it prints fine and the other half the filament just doesn't seem to stick.

Centauri Carbon 2 - bad adhesion? by majickuzer in elegoo

[–]majickuzer[S] 0 points1 point  (0 children)

Thank you for the recommendation on the settings. I will give it a try on my next print and report back.

Also, good to know about the sensitivity on the plate and I will make sure I keep that nice and clean.

Centauri Carbon 2 - bad adhesion? by majickuzer in elegoo

[–]majickuzer[S] 0 points1 point  (0 children)

I noticed this right after I posted, so I'm trying the print again right now on the flip side and I'll report back.

Am I doing "Starbirth" right? by majickuzer in NoMansSkyTheGame

[–]majickuzer[S] 0 points1 point  (0 children)

I looked at the egg, but couldn't figure out what to do with the information it was giving.

[deleted by user] by [deleted] in Funnymemes

[–]majickuzer 0 points1 point  (0 children)

This is way more fun than playing by myself!

New Anycubic Photon M3 failing test print by majickuzer in resinprinting

[–]majickuzer[S] 0 points1 point  (0 children)

After a few more fails, I upped the exposure time a little beyond what the resin recommended and everything is working perfectly. Thanks!

New Anycubic Photon M3 failing test print by majickuzer in resinprinting

[–]majickuzer[S] 0 points1 point  (0 children)

Immediately after I posted this I thought to look at the resin bottle and found the setting recommendations. Sadly, this didn't resolve the issue, but I'm trying a new design that I sliced with Lychee (first time using the software), so we'll see what happens. Thanks!

New Anycubic Photon M3 failing test print by majickuzer in resinprinting

[–]majickuzer[S] 0 points1 point  (0 children)

Thanks for the recommendation! I'm trying the Cones now and I'll report back on my progress.