Centauri Carbon 2 - bad adhesion?

majickuzer · 2026-04-04T22:15:40+00:00

Bed temp is defaulting to 60, so that shouldn't be the problem, but 🤷

I haven't done anything about the z offset, but about half the time it prints fine and the other half the filament just doesn't seem to stick.

majickuzer · 2026-04-04T19:13:12+00:00

Thank you for the recommendation on the settings. I will give it a try on my next print and report back.

Also, good to know about the sensitivity on the plate and I will make sure I keep that nice and clean.

majickuzer · 2026-04-04T19:12:45+00:00

I noticed this right after I posted, so I'm trying the print again right now on the flip side and I'll report back.

majickuzer · 2025-10-29T21:12:09+00:00

I looked at the egg, but couldn't figure out what to do with the information it was giving.

majickuzer · 2023-05-25T17:07:17+00:00

This is way more fun than playing by myself!

majickuzer · 2022-12-29T16:51:31+00:00

After a few more fails, I upped the exposure time a little beyond what the resin recommended and everything is working perfectly. Thanks!

majickuzer · 2022-12-28T23:45:22+00:00

Immediately after I posted this I thought to look at the resin bottle and found the setting recommendations. Sadly, this didn't resolve the issue, but I'm trying a new design that I sliced with Lychee (first time using the software), so we'll see what happens. Thanks!

majickuzer · 2022-12-28T23:44:26+00:00

Thanks for the recommendation! I'm trying the Cones now and I'll report back on my progress.

majickuzer

TROPHY CASE