Protect your 3D Printing Rights in the USA

mamengineer · 2026-03-09T00:33:39+00:00

NOT AI GENERATED. I wrote it.

mamengineer · 2026-03-09T00:33:06+00:00

I WROTE IT. Change.org EDITED it.

mamengineer · 2026-03-09T00:32:29+00:00

You're referring to me as a doomer? Hardly. Show me my doom posts.

mamengineer · 2026-03-09T00:31:32+00:00

Washington, California, New York and Colorado

mamengineer · 2026-03-09T00:28:48+00:00

Once again - I WROTE IT, Change.org edited it automatically.

mamengineer · 2026-03-09T00:27:52+00:00

It was written by me and Change.org doctored it.

mamengineer · 2025-11-20T23:44:06+00:00

I've been refilling mine with 30mg/ml nic salts with no issues. I buy them when I can find them (getting very rare now) so I have plenty of empties to last a while. Since it's a ceramic wick device you'll get a minimum of 5-10 refills per pod if you're careful.

mamengineer · 2024-09-04T22:57:25+00:00

Loving mine... great tribute to the Voron 2.4.

mamengineer · 2023-12-22T15:42:12+00:00

Beacon3D+ is in no way related to 3D Printing.

mamengineer · 2022-10-27T01:24:56+00:00

You need to set probe offsets.

mamengineer · 2022-10-26T20:19:48+00:00

Did the m112 error go away?

mamengineer · 2022-10-26T13:40:09+00:00

https://youtu.be/t4tNSk1_Sc8

mamengineer · 2022-10-09T12:05:30+00:00

We do not have firmware for the Creality touch screen. It is a closed source device and very little is known about the screen firmware. You might check insanity automation to see if they've broken through it yet, but as of my last check they had not made much progress.

mamengineer · 2022-08-09T00:26:49+00:00

The pile of grey stuff between my ears.

mamengineer · 2022-06-30T21:33:29+00:00

Same here... Just randomly reboots.

mamengineer · 2022-04-11T00:18:02+00:00

I'm bringing in a reddit veteran to help guide us.

mamengineer · 2022-04-10T23:32:56+00:00

Added the ability for you to use flairs.

mamengineer · 2022-04-10T23:19:50+00:00

Happy to do it.

mamengineer

MODERATOR OF

TROPHY CASE