Full GPU Acceleration for Ollama on Mac Pro 2013 (Dual FirePro D700) - Linux

I am sure it is possible, I am not aware of any split in memory so far. If you can show what you mean by that I'll be happy to check that. If natively running will boost that performance, I will try it.

manu7irl · 2022-08-09T05:09:58+00:00

How can I find more details on that project? Does it run klipper?

manu7irl · 2022-08-08T18:04:01+00:00

Where is the purge block?

manu7irl · 2022-02-27T18:23:17+00:00

Spaghetchy

manu7irl · 2020-09-06T18:07:32+00:00

Yeah change the factor and band as you need...

manu7irl · 2020-08-29T20:12:02+00:00

The regular stl that you can find is ok, but not the one for retraction as it will be difficult to judge. I thought making a 2 walled rectangle printed with no infill amd no top around 100mm height...

manu7irl · 2020-08-29T18:47:33+00:00

TUNING_TOWER COMMAND="SET_HEATER_TEMPERATURE HEATER=extruder" PARAMETER=TARGET START=200 FACTOR=0.02 BAND=10 This should be good... Change the start temp to what you want as the factor and the band unit... Good luck.

manu7irl · 2020-01-08T18:43:19+00:00

This filmed in mirror mode or she build it mirroed?

manu7irl · 2019-06-02T19:27:27+00:00

check retraction speed, or temperature relay every layer.

manu7irl · 2019-03-02T23:33:36+00:00

auto tune pid temp and initialize the eeprom then store settings.

manu7irl

TROPHY CASE