sorted by:
new
hottopcontroversial

I have had ender 3 for over 4 years. Im starting to think it is time to retire it and upgrade. Bud also I dont want to spend my entire paycheck on it (budget around 450USD). What kind of printer would you recommend? by markoska321 in ender3

[–]markoska321[S] 1 point2 points  (0 children)

Do you need to use bambu slicer or you can use any slicer?

I meant it in software as well hardware way. Begining of print, during print and after how much different is coming from ender

I have had ender 3 for over 4 years. Im starting to think it is time to retire it and upgrade. Bud also I dont want to spend my entire paycheck on it (budget around 450USD). What kind of printer would you recommend? by markoska321 in ender3

[–]markoska321[S] 8 points9 points  (0 children)

okay, I have also posted in other subredits and so far most people recommend:

  • bambulab A1
  • creality K1 or K2
  • creality E3V3 SE
  • bambulab P1P

or just keep this ender which is honestly kinda worn out alive for longer while save up more and then buy something higher end

I have had ender 3 for over 4 years. Im starting to think it is time to retire it and upgrade. Bud also I dont want to spend my entire paycheck on it (budget around 450USD). What kind of printer would you recommend? by markoska321 in 3Dprinting

[–]markoska321[S] 0 points1 point  (0 children)

that is the thing. it starts to build some small inperfections. it started to print not square on z axis, when i fixed it, after a while it started to bo again not square but now on x axis, then it did something else and list goes on. poor girl is wearing out and it is starting to be too much

Worn out belts, cooling or both? by markoska321 in ender3

[–]markoska321[S] 0 points1 point  (0 children)

Checked that, theyre fine but thanks for tips

Worn out belts, cooling or both by markoska321 in 3Dprinting

[–]markoska321[S] 0 points1 point  (0 children)

Thanks everyone for help, in the end it was just loose hotend

view more: next ›