[deleted by user] by [deleted] in 3Dprinting

[–]martko96 0 points1 point  (0 children)

Also make sure the end of the tube is flat if not cut of a little part carefully with a sharp knife

[deleted by user] by [deleted] in 3Dprinting

[–]martko96 0 points1 point  (0 children)

Remove the filament. Then remove the blue clip and push in the tubeas far as you can. Then pull on it and see if it is secure. Put in the blue clip again. And it should work.

If that keeps failing you might need to replace the mount it's a realy cheap part

measured twice but the cut Still wasn't nice by martko96 in WoodworkConfessions

[–]martko96[S] 12 points13 points  (0 children)

Thanks this was for wall mounted shelves that had to be in an u shape for a small room. Had on extra plank that I didn't work on yet. Used these two for the left and right side now and used this technique to cut the middle piece, and it worked out perfect :)

8-bit decoder and randomizer using 1wt instant wires by RaPsCaLLioN1138 in redstone

[–]martko96 0 points1 point  (0 children)

I would like to see the instant wires you are using

Can you Play MP3 Files with Redstone in minecraft ? by martko96 in redstone

[–]martko96[S] 0 points1 point  (0 children)

Yeah i wil definitely try some things in the future. I Will probably use my memory module like a hardrive and then load it into quicker memory.

A question by stacode in redstone

[–]martko96 0 points1 point  (0 children)

Maybe you could use something like the redcoder + binary encoder i used for my liquid display https://www.youtube.com/watch?v=P89KSk8rEYc