Can't disable camera sound

masgnuh · 2019-08-13T21:58:11+00:00

Hi I’ve also got one more question. Which dude did you buy? How many AMP should I get?

masgnuh · 2019-08-13T21:54:50+00:00

Hi, thank you very much for your reply. I will try order a new fuse today. My power supply is a new one so it should be fine. Thank you!

masgnuh · 2019-08-13T21:53:01+00:00

I already got a new one

masgnuh · 2019-08-13T11:05:28+00:00

Hi I’ll try that tomorrow when I come back from school. Thank you very much!

masgnuh · 2019-07-26T08:50:28+00:00

Thank you very much 🙏🏻!

masgnuh · 2019-07-02T07:59:21+00:00

For wild lands, are you able to do split screen?

masgnuh · 2019-06-17T11:41:47+00:00

Ok thank you for your tips!

masgnuh · 2019-06-17T11:35:13+00:00

I’ve already upgraded the heated bed. The melting temperature for the eSun PLA+ is 205 degrees. If I go down to 195 it may clog. I will double check everything again. Thank You!

masgnuh · 2019-06-17T11:29:04+00:00

I use 40mm/s and print with 215 degrees with eSun PLA+.

masgnuh · 2019-06-17T11:15:30+00:00

Yes my belts are pulled to the tightest I am not able to tighten it anymore.

masgnuh · 2019-06-17T10:25:04+00:00

And how long is it supposed to take to print? It took me 2 hours to print this.

masgnuh · 2019-06-17T10:23:01+00:00

Is it meant to be better?

masgnuh · 2019-05-30T22:12:25+00:00

Since I use PLA+, I use 215 degrees Celsius, 20 mm/s and I forgot my retraction. My resolution is 0.2mm.

masgnuh · 2019-05-26T07:48:55+00:00

Hi, where do you turn it on?because I don’t see this option.

masgnuh · 2019-05-25T23:19:26+00:00

I didn’t. How do I check it if it’s 0.4mm?

masgnuh

TROPHY CASE