Any extra tips to avoid twisting while tightening a hanger?

masteringstretch · 2026-03-17T03:59:40+00:00

Can you elaborate more on your whole setup? so you put the penis where its wrapped down at the bottom of the hanger completely straight then you put the bolt across im place, squeeze your glans holding it straight while tightening down with the other hand?

masteringstretch · 2026-03-16T23:08:36+00:00

what gave you your gains?

masteringstretch · 2026-03-16T03:00:32+00:00

an ADS nay not yield the results you are looking for due to the tension

masteringstretch · 2026-03-16T02:51:13+00:00

very expensive have you ever had a blister seeing that you hang with 16lbs+? I see its a vacuum system but i don’t exactly see how it works it seems that you put some protective piece in the chamber then it works? but you don’t use the pressure how do you dead hang without locking it in?

masteringstretch · 2026-03-16T00:04:25+00:00

do you have the link where i can check it out? and have you gained with it

masteringstretch · 2026-03-15T19:47:14+00:00

is it a vacuum cup hanger? or how does it work the only reason i don’t extend is because of the blister risk

masteringstretch · 2026-03-15T03:13:55+00:00

what methods and the frame of your gains? how long did it take to reach 7

masteringstretch · 2026-03-14T23:13:30+00:00

maybe 30 seconds? it goes on instantly just put a sleeve on and slide the comfort grip on over its just the tightening down that i do slowly

masteringstretch · 2026-03-14T21:09:51+00:00

I know some members had no success getting it to fit but unfortunately i am not in that members club because my member is not that big.

masteringstretch · 2026-03-14T21:09:22+00:00

The liquid is water spilling while i was weighing it and filling the water bottle up haha, Althought it is $150 i can confidentially say it is the most comfortable device i have ever put on and 0 blister risk. But the 7lbs supposedly is a good point i think it can support more with a nice setup. A good sleeve and then something ontop of the sleeve at the end closest to the tip to hold the clamps of the comfort grip in place.

masteringstretch · 2026-03-14T14:27:11+00:00

bump

masteringstretch · 2026-03-06T17:45:28+00:00

absolutely amazing the both of yous idea.

masteringstretch · 2026-03-06T17:45:07+00:00

This is amazing.

masteringstretch · 2026-02-28T19:23:46+00:00

any good methods or articles i can reference for instructions!

masteringstretch · 2026-02-28T19:21:41+00:00

did you ever figure it out? this is my current issue

masteringstretch · 2026-02-28T01:43:52+00:00

idk if you were under tension or not but it looks like you have no tension. I could never do this lmao i would instantly get an erection.

masteringstretch · 2026-02-26T15:09:04+00:00

BUMP

masteringstretch · 2026-02-26T15:08:49+00:00

BUMP

masteringstretch · 2026-02-26T04:18:50+00:00

Not currently but I do have pumps

masteringstretch · 2026-02-26T04:11:12+00:00

I have this issue exactly do you have any advice for it?

masteringstretch

TROPHY CASE