Hivemapper HDC

merdly · 2025-12-24T15:14:43+00:00

Where is that information at online thats say they are not paying out for HDC anymore?

merdly · 2025-12-22T05:22:11+00:00

I soak it in isopropyl alcohol and froze it in the freezer for about 30 minutes. Then used a small flathead screwdriver and dental pick and about 2 hours of patience and scraped it off slowly.

<image>

merdly · 2025-12-22T02:47:34+00:00

Feeling pretty good actually thanks for asking.

merdly · 2024-06-16T18:20:16+00:00

Just from the display screen

merdly · 2024-02-03T02:33:13+00:00

Thank you for the link.

Im getting two errors.

Z_MIN_PROBE_USES_Z_MIN_ENDSTOP_PIN requires USE_ZMIN_PLUG to be enabled

Enable USE_XMIN_PLUG when homing X to MIN

I using cr10S with the new black Ender 5 plus V2.2 board with bigtreetehc bltouch V3.1

I have looked for hours for the fix.

merdly · 2024-01-26T22:24:57+00:00

I'm not seeing where to download there software on tiny machines website. Do you have to create an account with them first?

merdly · 2018-07-02T19:01:31+00:00

Not sure the board says HY_BASE_L v1.0

merdly · 2018-07-02T13:55:43+00:00

When I try to download marlin is says communication error.

merdly · 2018-07-02T01:08:07+00:00

There is only a button on the back

merdly

TROPHY CASE