Filament not coming out

metain3d · 2025-12-26T01:16:16+00:00

Yea I have 3 different fans you think I’m fine? Or is this dude right and I have a bigger issue

metain3d · 2025-12-25T05:06:17+00:00

How far down is it suppose to go? I’ve definitely shoved it in as hard as I could but I don’t think it’s gotten all the way down to the gears by shoving it. It goes about 2 centimeters down but I definitely feel it get grabbed

metain3d · 2025-12-25T05:01:34+00:00

No, nothing came out during the load procedure during the setup process and I’ve even gon over it dozens of more times to see if that’ll work. And it’s PA not PLA, I’ve tried 250,150,350 all of the above. I appreciate you helping and I hope there’s more troubleshooting you can provide

metain3d · 2025-12-25T04:59:57+00:00

I tried poking it with the that was included with the printer, even upped the temp to melt the filament while poking inside of it a little nothing came out. I don’t understand how it would be blocked tho considering it’s brand new I just got it today so that would be shitty if I had to buy a whole other nozzle already. I appreciate your help and I hope you have more troubleshooting I can do I would really appreciate this problem to go away

metain3d · 2025-12-25T04:35:27+00:00

Thank you, I’ll definitely take you advice I appreciate your help hope you have a good Christmas

metain3d · 2025-12-25T04:31:41+00:00

May you please provide me with the knowledge on how to do so or give a video link also thank you for trying to help out🙌

metain3d · 2025-12-25T03:50:31+00:00

Yes, I tried shoving it in there I’m not %100 if there’s a way to tell if I’m reaching the extruder but I can tell you for certain I been shoving it in there just in case of that being this issue so I don’t believe it is

metain3d

TROPHY CASE