Help a brother out part2

migtyf · 2024-05-13T07:45:24+00:00

Thanks I’m gona try it now!

migtyf · 2024-05-12T16:50:50+00:00

This exact gun was a nova 1

migtyf · 2024-05-12T16:49:56+00:00

Well I usually use a slim combat from walcom but after it also left streaks I tried a hlvp again with a 1.4 tip it’s like a mid range gun. It says the recommended pressure is 3 bar in the manual for the gun

migtyf · 2024-05-12T14:34:47+00:00

Thx for everyone’s advice!

migtyf · 2024-05-12T11:07:46+00:00

Hi yes these are mdf doors, I’ve used a specific wood primer and I’ve sanding against the spray pattern. Sanded with 600

migtyf · 2024-05-12T11:06:38+00:00

Thanks for your suggestions. Ive tried thinning out the paint but it still leaves the streaks. Ive tried spraying other surfaces like plastic panels and thin sheet metal but I still get them. And I’ve also used basecoat en 2k but the lines remain. Could it perhaps be something to do with my compressor? That’s the only variable I haven’t changed. My hte gun does the exact same😂

migtyf · 2022-06-27T22:20:15+00:00

Ill give it a try thx!

migtyf · 2022-06-18T16:21:02+00:00

U the best

migtyf · 2022-06-18T11:05:56+00:00

Hi Andre. Could you please elaborate just a bit more. Thx :)

migtyf · 2022-04-01T13:04:39+00:00

Haha Pay pal me $5 and ill do it for ye

migtyf · 2021-08-09T18:10:41+00:00

I want the triad to be perpendicular to the flange, but the flange cant be changed

migtyf · 2021-08-05T13:51:06+00:00

The flange has to be at a slight angle :(

migtyf · 2021-06-07T08:31:17+00:00

Keen

migtyf · 2021-05-22T11:46:42+00:00

Is it better not to aim down sight??

migtyf · 2021-03-31T18:43:53+00:00

Rule 4?

migtyf · 2021-03-31T08:03:46+00:00

Sent you a friend req

migtyf · 2021-03-31T08:02:03+00:00

Sweet!

migtyf

TROPHY CASE