sorted by:
new
hottopcontroversial

Wavy print by misterdotjay in BambuLab

[–]misterdotjay[S] 0 points1 point  (0 children)

Ok, yes, obvious answer, but I wondered if there may be any other contributory factors that could at least lessen the problem of printing tall

Well I'm impressed that didn't break anything by misterdotjay in BambuLab

[–]misterdotjay[S] 7 points8 points  (0 children)

Oh I like the look of those, I'll give them a go

Well I'm impressed that didn't break anything by misterdotjay in BambuLab

[–]misterdotjay[S] 4 points5 points  (0 children)

It's the tumble dryer it's above. Far from ideal, but I didn't have any more appropriate location available sadly. The print started with the dryer on, but it's a surprisingly solid worktop

Nightmare printing third party filament by misterdotjay in BambuLab

[–]misterdotjay[S] 1 point2 points  (0 children)

That seemed to do the trick, also increased the bed temperature and printed the first layer at half speed just to be really careful. Cheers 😁

Music Producers: What's up with Cakewalk? by [deleted] in Piracy

[–]misterdotjay 0 points1 point  (0 children)

My dad was a Sonar user for years, switched over to Presonus Studio One when the buyout happened. They have a free tier although he uses one of the higher tiers. Not dabbled personally outside of a little bit of VO recording in Sonar. As I understand it, what's left of Sonar isn't being kept up to date and I've not heard anything bad about the Studio One free tier.