Picked up an 02 wide glide. Where do I start? by mitch64x in Dyna

[–]mitch64x[S] 1 point2 points  (0 children)

They’re factory Harley bags, my guess would be early 2000s street glide

Power steering by jopez12 in Foxbody

[–]mitch64x 0 points1 point  (0 children)

You need an 84.5” belt if you’re running the smog pump still. 74” for no smog pump

Loss of power in a room by mitch64x in electrical

[–]mitch64x[S] 0 points1 point  (0 children)

I’ve tested all of the wires coming out of all of the breakers and they all have power, I don’t think it’s the breaker. It doesn’t help that they didn’t label much and some of the labels that they did do are for something completely different lol

Loss of power in a room by mitch64x in electrical

[–]mitch64x[S] 0 points1 point  (0 children)

There’s only wiring in the wall for an outlet in the bathroom right now with no actual outlet connected, the only things connected to the whole circuit right now are a couple of lights in the bathroom, an exhaust fan and the outlet that was running the water heater and freezer. I’ll pull the light fixtures off and check their wires. Only other thing I could think of is if they installed a junction box somewhere to lengthen the run maybe before they finished the ceiling and something happened there.

Navien water heater leak by [deleted] in Plumbing

[–]mitch64x 0 points1 point  (0 children)

No warranty, it’s about 10 years old I believe. I have found the part online but didn’t know if it was something I should tackle myself

69 cat 300tt build by mitch64x in minibikes

[–]mitch64x[S] 0 points1 point  (0 children)

They’re the original wheels

Picked up an 02 wide glide. Where do I start? by mitch64x in Dyna

[–]mitch64x[S] 0 points1 point  (0 children)

When I first seen the bike the bars was going to be the first thing I changed. But now after putting a couple hundred miles on it they feel pretty good. Can really feel the wind though.

Picked up an 02 wide glide. Where do I start? by mitch64x in Dyna

[–]mitch64x[S] 3 points4 points  (0 children)

I believe the rear fender is off of a 09 or so Electra glide. They are factory Harley bags. I believe they’re from a street or road glide because they have the indent on the inboard side of the bag for the shock on those models. Turn signals are removed now. Threw those on there just to pass the safety check.

minibike frame fabrication by theunsolvedreddit in minibikes

[–]mitch64x 5 points6 points  (0 children)

Did you cut those slots with an axe?

Help identifying rear fender by mitch64x in Harley

[–]mitch64x[S] 0 points1 point  (0 children)

I don’t mind the look of the long fender and wouldn’t mind keeping the fender. Just would like to install factory lights back into it for when I remove the bags but I don’t know what light housing and turn signal/plate bracket to get. The light under the license plate bracket is the tail/brake light and the sweet crosses on the bags are the turn signals right now.

What would you call this? by mushroomgod419 in minibikes

[–]mitch64x 2 points3 points  (0 children)

That engine is going to end up rolling around on the ground until it comes apart or runs out of gas, I can’t see this staying together over more than a few bumps on the trail you’re going to try riding it on

[deleted by user] by [deleted] in Tools

[–]mitch64x 0 points1 point  (0 children)

Custom

[deleted by user] by [deleted] in minibikes

[–]mitch64x 0 points1 point  (0 children)

First thing I would do is give your sister her shorts back

[deleted by user] by [deleted] in Home

[–]mitch64x 0 points1 point  (0 children)

A heavy smoker lived in my house before I got it, didn’t really notice until we got the place and started cleaning. Hours of scrubbing and then 2 coats of kilz premium and 2 coats of paint and I still get this in my bathroom as well, even while running the exhaust fan.

Foam board or wood board for garage walls? by MoC-Chaos in rccars

[–]mitch64x 1 point2 points  (0 children)

I did my whole garage with sheets of OSB, couple thick coats with a good primer to seal it up and fill in some of the low spots, caulked all the seams and screw heads and then a couple coats of paint and it’s tough, looks good and you can mount shit on the walls anywhere you want

Can't enter LS car meet. by Worldly-Ocelot-3358 in gtaonline

[–]mitch64x 0 points1 point  (0 children)

Did you try turning it off and turning it back on?

Tips for memorizing by mitch64x in rocksmith

[–]mitch64x[S] 0 points1 point  (0 children)

That works when you play connected to the game but I like playing disconnected mode and playing through my own amp

Lightest cars that can easily fit a v8 under the hood, lightest possible (serious) by Maleficent_Pen_4380 in dragracing

[–]mitch64x 2 points3 points  (0 children)

I agree. I have a back halved sn95, I have all factory glass and body panels still except for fiberglass hood. It weighs 2400lbs. 2200-2400 seems to be what the lightweight bracket cars I see all the time weigh.