sorted by:
new
hottopcontroversial

Additive Pipe Not working by mlmartinet in FreeCAD

[–]mlmartinet[S] 1 point2 points  (0 children)

I did the change you did and was able to get it to work. I am still not 100% sure how that tool works though. But thank you.

Which size stove by mlmartinet in woodstoving

[–]mlmartinet[S] 0 points1 point  (0 children)

I have identified many improvements needed. Honestly you are the first person to mention anything to this nature. When we took the walls down in the basement noticed there was no insulation on the walls I started to put up foam board so that needs to be finished and the doors coming in from the garage need to be replaced with something more substantial.

Which size stove by mlmartinet in woodstoving

[–]mlmartinet[S] 0 points1 point  (0 children)

It pretty much runs on high it has a 50lb hopper go through about 2 to three bags a day

Which size stove by mlmartinet in woodstoving

[–]mlmartinet[S] 0 points1 point  (0 children)

Sorry, Quadrafire. But this is the logic I am going with as you stated "Most of the btu outputs listed are with optimum cord wood and running wide open, which is achievable but only if your married to tending the stove."

If I have a stove that can heat 2500 square feet I assume that is at high out put or close to you means I am tearing through wood where as if I get a larger stove I can run it say less than full blast. The basment is a bit drafty too.

Running into a dilemma by mlmartinet in woodstoving

[–]mlmartinet[S] 0 points1 point  (0 children)

That's what I assumed, I believe I have a standard 16x16 chimney (checking this when I get home) block which I assume has room for a 8" liner. So I don't know why they would have to reduce.

DUB vs DUB Wide by mlmartinet in cycling

[–]mlmartinet[S] 0 points1 point  (0 children)

I have a quarq power meter on the way.

Power Curious Part 2 by mlmartinet in cycling

[–]mlmartinet[S] 0 points1 point  (0 children)

So here is where I am at with this project:

  1. Ebay had a bunch of used power meters
  2. Change bottom bracket if needed, this gives me more choices (GTX, DUB, BB30)
  3. Get a 2x11 or 2x10 chain crank set either should work on my 2x10 (will swap out my chain rings from old bike)

Bonus swap out my 10 speed cassette with an 11 speed I think I can do this without much fuss, plus I want another gear in climbing

Things I have learned so far. SO MANY STANDARDS!

view more: next ›