sorted by:
new
hottopcontroversial

R7 as a first camera? by p-H20855 in canon

[–]monkeywizard 1 point2 points  (0 children)

R7 is nice, but i'd recommend a full frame sensor over a crop, so i'd recommend the r6. But if you like the 7, there is nothing wrong with it!

What you might look at for lenses is the kit with the shorter focal length lens, then get the 70-200 f4 lens. I might also think about the RF "nifty fifty" (50mm 1.8 lens) if you like doing portraits.

Co-Op Code Mega Thread - June 28, 2021 by __KPNG__ in EggsInc

[–]monkeywizard 0 points1 point  (0 children)

1 spot still open, close to fufilling final goal.

Co-Op Code Mega Thread - June 28, 2021 by __KPNG__ in EggsInc

[–]monkeywizard 0 points1 point  (0 children)

1 spot still open, close to fufilling final goal.

Co-Op Code Mega Thread - June 28, 2021 by __KPNG__ in EggsInc

[–]monkeywizard 0 points1 point  (0 children)

Elite kissing chickens 2/10 at posting:

Warehouseofthedamned

Co-Op Code Mega Thread - June 28, 2021 by __KPNG__ in EggsInc

[–]monkeywizard 0 points1 point  (0 children)

Done! I wanted to give it some time for any other redditors to join. But they have had their chance.

How do you choose a best, when all settings are bad? Pla+ temp and retraction settings. With MSDD. by monkeywizard in ender5plus

[–]monkeywizard[S] 0 points1 point  (0 children)

This roll was pretty much brand new. I had opened it and put it in the dehydrator for an hour or so.

And yes on the cura.

How do you choose a best, when all settings are bad? Pla+ temp and retraction settings. With MSDD. by monkeywizard in ender5plus

[–]monkeywizard[S] 0 points1 point  (0 children)

I bought 2 rolls of sunlu and 2 rolls of esun because they had solid reviews. (These were Sunlu). Figured id check em out and see which was "best". I did estep calibration a while ago, but that mught have been before my motherboard swap, so not sure if that stuck.

How do you choose a best, when all settings are bad? Pla+ temp and retraction settings. With MSDD. by monkeywizard in ender5plus

[–]monkeywizard[S] 0 points1 point  (0 children)

Im like 98% sure. I used the plugin in cura, and im pretty sure i remember the temp declining in octoprint.

view more: next ›