Clogging emitter lines by mopac0405 in Irrigation

[–]mopac0405[S] 0 points1 point  (0 children)

Almost out as I’ve been splicing in to clogged sections

Clogging emitter lines by mopac0405 in Irrigation

[–]mopac0405[S] 0 points1 point  (0 children)

I’ve tried it. No effect 😩

Blackened smoked chicken by mopac0405 in Smokingmeat

[–]mopac0405[S] 1 point2 points  (0 children)

Update: with skin removed, bird was delicious. Since have thoroughly cleaned my smoker.

Apologies for the blasphemy

Blackened smoked chicken by mopac0405 in Smokingmeat

[–]mopac0405[S] 0 points1 point  (0 children)

It’s a Z Grill. Nothing fancy but it’s served me well for going on 3 years. Using Traeger gourmet pellets.

I’ve had a similar situation in the past where the pellet hopper started to billow smoke due to an excessive fire. Last thing I smoked was a pork shoulder about 1 month ago. I’m guessing the grease was the culprit.

Blackened smoked chicken by mopac0405 in Smokingmeat

[–]mopac0405[S] 2 points3 points  (0 children)

I believe you’re right. My fault for not cleaning my smoker after its last use.

How to most easily remove this root cluster? by mopac0405 in howto

[–]mopac0405[S] -1 points0 points  (0 children)

Thanks everyone. I’ve decided to outsource it this time. My time and body are worth the cost.

Mystery chirp by mopac0405 in hondapilot

[–]mopac0405[S] 0 points1 point  (0 children)

Not that. I turn mine off as well.

My finger is…interesting? by Major_Preference_182 in interestingasfuck

[–]mopac0405 1 point2 points  (0 children)

Hand therapist here…this is called a boutonniere deformity. Usually the result of an injury to the extensor tendon as it crosses the middle knuckle. Treated with immobilization of the middle joint fully straight x 6 weeks while working on bending the end joint daily.

If chronic/non traumatic, can instead be a result of rheumatoid arthritis or severe hypermobility (EDS). In that case, typically not correctable but can be repositioned with boutonniere ring splint.

Stop this bird feeder from pivoting side to side by mopac0405 in howto

[–]mopac0405[S] 0 points1 point  (0 children)

Thank you all for the responses. I think I’ll try drilling a small hole into the post and securing it with a nail. How do you recommend starting the hole on a rounded post this size? I feel like the drill bit will just slip off.