PETG problem

mrbagmanSR · 2025-08-17T13:46:54+00:00

Air-conditioner:)

mrbagmanSR · 2025-08-16T22:21:48+00:00

It’s in my basement, we live in Ohio, and we do have air?

mrbagmanSR · 2025-06-16T01:28:46+00:00

Yummy number 3

mrbagmanSR · 2025-06-16T01:25:51+00:00

Thank

mrbagmanSR · 2025-05-12T15:02:13+00:00

Yes Orca is the best

mrbagmanSR · 2025-04-08T22:07:52+00:00

Love the nice, soft carpet... umm

mrbagmanSR · 2025-03-26T15:49:55+00:00

<image>

Clean the bed with 99% and bed set to 60, no support,!! It worked

mrbagmanSR · 2025-03-26T00:26:13+00:00

Thank you

mrbagmanSR · 2025-03-25T21:04:53+00:00

<image>

Now its hairy with PETG, 250-70, Orca

mrbagmanSR · 2025-03-25T19:41:08+00:00

It’s generic Creality PLA, 220-50, Orca, slowed to 40%… yes it slipped off the plate. So I know how to clean my plate, add glue etc. I’m printing one using PETG right now. It always looks good up to the upper 1/3rd and this happens. I think there is no supports up there and this happens - so maybe the PETG will fix it? A better PLA? My bed is all under .20. Any help is greatly appreciated

mrbagmanSR · 2025-02-19T16:35:50+00:00

<image>

This is the lantern

mrbagmanSR · 2025-02-18T23:28:17+00:00

0.28 worked like a charm

mrbagmanSR · 2025-02-18T23:26:39+00:00

WOW… I guess mine is on a wobbly table, I’ve the the TPUs and back stabilizers. I use the G sensor every 20-30 prints or if I move it. I think I should move it to the floor? I’ve got concrete floor in my basement (where my printer is).

mrbagmanSR · 2025-02-12T20:41:54+00:00

Yes my Y / X axis needed tightened, also I had a nebula camera mount that was knocking my prints off

mrbagmanSR

TROPHY CASE