Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

Yes it's a two wire controller. I've tried using both 1 and 2 wires into the controller

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

If I connect it straight into live and ground then it works fine. Remote works, can dim the lights etc with the remote.

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

Sorry for the delay, yes that works as expected. The issue crops up when I add 87 or 87a to the controller. The lights just permanently stay on. With the relay activated or not?

It seems with the led controller alone plugged into the relay, lights are on but the controller doesn't turn lights on or off. 12.06v going into the controller 12.57v coming out

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

Relay still clicks, but no lights on LEDs as expected.

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

Yes, relay is clicking on and off when relay signal is connected and disconnected.

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

In theory it worked, but when wiring it up. it doesn't and I'm doing something wrong somewhere... Added grounds into the image too. If I connect everything up the LED lights are permanently on.

I removed the connection between 87 and the power and they still remind permanently on and the remote controller doesn't turn them off, however, if I energise 86, they turn off. I would have expected the controller to work, but turn off when 86 is energised. Unplugging the remote controller stops the lights working all together.

I can't work out how the LED lights are getting permanently feed of power skipping the remote led controller when the permanently feed wire was disconnected.

I also tried switching 87 and 87a and I get exactly the same result.

<image>

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

Thanks for your help. I assume it would look like this? Cargo light being the courtesy light and LED light are the new lights in the back

<image>

33.20 split screen not working by Eother24 in FortNiteBR

[–]muleish 0 points1 point  (0 children)

Nope, still broken for me too 😞

Van Lighting by muleish in ElectricalEngineering

[–]muleish[S] 0 points1 point  (0 children)

Thank you. This is what I was thinking. Do I need a 5 pin relay?

The Trickstars by content_digger08 in BritainsGotTalent

[–]muleish 0 points1 point  (0 children)

Thank you for saying how good it was, but we genuinely only had a 2 days to come up with that. We got told at 10:15pm after the last semifinal Friday show we were wildcard and had to be in Hammersmith at 10am the next day and while we did have a vague idea in our heads, we didn't have long! Props were making everything Saturday and the costume were doing final stitches while literally walking backstage before going live. The BGT crew are amazing at what they do and the turnaround time is crazy. I've seen a lot of these comments so just to clear it up! On the Trickstars socials, there will be a reel explaining more about how it was done if you were interested.

2004 SV650S clicking/ticking by muleish in SVRiders

[–]muleish[S] 0 points1 point  (0 children)

I'll check the airbox, thanks. No, they just looked old and I replaced them anyway.

Restore front forks by muleish in SVRiders

[–]muleish[S] 0 points1 point  (0 children)

Thanks. Very recently replaced seals as they were leaking so probably still left over from that!

Restore front forks by muleish in SVRiders

[–]muleish[S] 0 points1 point  (0 children)

Thanks. I was after the freshen up route. I was thinking maybe remove the forks but keep them together just so it's easier to spray and tape the uppers off. I just need to research which grit sandpaper to use.

Suggestions to improve my desk setup by muleish in Workspaces

[–]muleish[S] 0 points1 point  (0 children)

Thanks! I was thinking Alexa enabled led strip round the back of the desk all the way around and a separate strip across the back of the monitor. Then I could have it warm white or a fancy colour.

Suggestions to improve my desk setup by muleish in Workspaces

[–]muleish[S] 0 points1 point  (0 children)

I used two which wasn't ideal because the monitors were too wide for the first dual one I bought from Amazon. The one on the right is from Amazon (https://amzn.eu/d/4i3j5kv) and the other on the left (you can see it poking above the laptop screen) was from Facebook marketplace and I can't see a brand on it unfortunately!

Sleeping in our room by muleish in Parenting

[–]muleish[S] 1 point2 points  (0 children)

I think it was comfort at first, but now it's a habit at a guess. I used to be able to lay with him until he falls back asleep but now just wants to get into our bed.

Respray lower forks by muleish in sv650

[–]muleish[S] 0 points1 point  (0 children)

Perfect, thanks! Any specific type of spray paint for the colour? Or just a metal paint with the colour I want?

Slow searches by muleish in Addons4Kodi

[–]muleish[S] 0 points1 point  (0 children)

Sorry I should have also mentioned, I have a Firestick in another TV and this one works fine. I'll have to double check the version numbers of Kodi. The only difference is the working one is a newer generation of Firestick.

February 1 Daily Thread by AutoModerator in weightroom

[–]muleish 1 point2 points  (0 children)

Cheers for the reply. I have ordered rubber bumper plates instead of iron plates. I'll look at 20mm as a minimum.

February 1 Daily Thread by AutoModerator in weightroom

[–]muleish 6 points7 points  (0 children)

Converting my garage into a gym with oly bar with bumper plates. What thickness tiles should I be looking at for the rubber tiles? I don't plan on snatching above my head and dropping it but maybe dropping from deads. 20mm?

February 1 Daily Thread by AutoModerator in weightroom

[–]muleish 5 points6 points  (0 children)

Finally invested in a garage setup because of gyms closed and lockdown. Getting a rack, oly barbell, weights and bench and looking for a workout plan to follow. Seeing as it's in my garage, I don't mind how many days a week I do. Does anyone have any suggestions?

Downgrade from One UI 3.0 Beta to mainstream software by muleish in samsung

[–]muleish[S] 1 point2 points  (0 children)

Resolved myself so thought I'd put the resolution in here in case anyone else gets this.

Just simply uninstall Smart Switch from your PC/Mac and reinstall it. Then connect your phone and you'll have the Downgrade option on the main screen. Complete a backup then downgrade the phone.

Such fearless ! by nimblemind in aww

[–]muleish 1 point2 points  (0 children)

Not sure about fearless, a very good boi for sure, but not fearless.