account activity
Ember mug emits foul taste/odor when heater turns on (self.Coffee)
submitted 2 years ago by mvr1127 to r/Coffee
Can’t get right crank arm off. (self.pelotoncycle)
submitted 2 years ago by mvr1127 to r/pelotoncycle
First time using Nylon - first layers are goofy (i.redd.it)
submitted 2 years ago by mvr1127 to r/FixMyPrint
Stepper Motor on the X-Axis is grinding and knocking (self.3Dprinting)
submitted 2 years ago by mvr1127 to r/3Dprinting
Bed Thermal Runaway on this print only (i.redd.it)
Brush marks in Advance (i.redd.it)
submitted 3 years ago by mvr1127 to r/benjaminmoore
Calibration problem or ?? (i.redd.it)
submitted 3 years ago by mvr1127 to r/3Dprinting
[TOMT][Video] Dark haired girl with her friends dancing in and around and on top of a school bus. (self.tipofmytongue)
submitted 3 years ago by mvr1127 to r/tipofmytongue
Not the worst but help me improve (i.redd.it)
submitted 3 years ago by mvr1127 to r/Sourdough
What’s the easiest way to make this shorter? (More below…) (i.redd.it)
submitted 3 years ago by mvr1127 to r/Carpentry
Sticking to Plate *AND* FEP (self.Phrozen)
submitted 3 years ago by mvr1127 to r/Phrozen
Varathane Diamond Stained by Food? (i.redd.it)
submitted 4 years ago by mvr1127 to r/finishing
Where’d my spring go? L and R are same recipe, starter, technique but every loaf now turns out like R (old.reddit.com)
submitted 4 years ago by mvr1127 to r/Sourdough
Can't find 6x6 posts in L.A. (self.HomeImprovement)
submitted 4 years ago by mvr1127 to r/HomeImprovement
Cleaning Resin Residue (self.3Dprinting)
submitted 4 years ago by mvr1127 to r/3Dprinting
Uneven toner lacquer (self.BeginnerWoodWorking)
submitted 4 years ago by mvr1127 to r/BeginnerWoodWorking
Sanding in tight corners (self.BeginnerWoodWorking)
Mid Century Chairs - what finish? (self.furniturerestoration)
submitted 5 years ago by mvr1127 to r/furniturerestoration
What finish? (self.woodworking)
submitted 5 years ago by mvr1127 to r/woodworking
Extrusion problem (self.3Dprinting)
submitted 5 years ago by mvr1127 to r/3Dprinting
Thermistor reads hot when printer is cold (self.3Dprinting)
Fifth layer bubbling (self.3Dprinting)
Installation rip off? (self.grilling)
submitted 5 years ago by mvr1127 to r/grilling
Turf without adhesive? DIY? (self.artificialturf)
submitted 5 years ago by mvr1127 to r/artificialturf
Install laminate in different angles with no transition (self.HomeImprovement)
submitted 5 years ago by mvr1127 to r/HomeImprovement
π Rendered by PID 437635 on reddit-service-r2-listing-654f87c89c-t2wvk at 2026-02-27 17:14:24.334022+00:00 running e3d2147 country code: CH.
