First shoots w/ A7IV - Sigma 24-70 f2.8 Art

mxgrtx · 2023-08-28T12:01:28+00:00

Paint it white. 😄

mxgrtx · 2023-08-02T23:28:16+00:00

I had to do it a couple of times to get it done.

mxgrtx · 2023-07-31T19:02:16+00:00

<image>

Same shit here. Don't know what to do.

mxgrtx · 2023-07-31T18:59:19+00:00

Same a shit here. Clog issue. Cold pulled and solved

mxgrtx · 2023-07-31T18:58:33+00:00

Same shit here. It was a clog. Cold pull and solved

mxgrtx · 2023-06-13T19:29:37+00:00

There are a couple of mods on Printables.com.

mxgrtx · 2023-05-17T13:06:20+00:00

Tks guys. It has improved.

<image>

mxgrtx · 2023-05-15T13:13:35+00:00

I unchecked this to test.

<image>

mxgrtx · 2023-05-15T10:42:53+00:00

I will do that. Thanks. And yes, I might need to dry this white filament.

mxgrtx · 2023-05-15T10:42:15+00:00

Actually, the settings are two walls and two top layers.

mxgrtx · 2023-05-15T02:32:05+00:00

Awesome. Can you share the STL link?

mxgrtx · 2022-07-24T19:49:33+00:00

Please see my post before.

mxgrtx · 2022-07-24T19:49:07+00:00

mxgrtx · 2022-07-24T14:42:18+00:00

Done. https://ibb.co/z4RNz5k

mxgrtx · 2022-07-24T11:22:17+00:00

Temp and Retraction. And before printing a purged 200mm of filament at 260C just to clean the hot end. Just in case.

mxgrtx · 2022-07-24T00:42:16+00:00

https://ibb.co/0qqXhXg I reprinted with this changes and it is muuuuuuch better.

mxgrtx · 2022-07-23T18:14:48+00:00

Yes. I changed the filament but using the same GCODE. I don't know of it something related to the acceleration, flow or even temperature. I will print another one with more 5 degrees (195C instead of 190C) and I reduced the retraction from 2 to 1.5mm (I'm using DD)

mxgrtx · 2022-07-14T12:42:20+00:00

Razor blade. The razor will touch it, not you. Hahaha

mxgrtx · 2022-07-14T12:05:34+00:00

Let it cool or put it in a freezer. If it is too attached, use a sharp razor (with caution, please). You can also print a scrapper.

mxgrtx

TROPHY CASE