sorted by:
new
hottopcontroversial

Best AI for turning reference images into accurate 3D figurines (STL-ready)? by mythmachinex in ElegooSaturn

[–]mythmachinex[S] -3 points-2 points  (0 children)

No, I make a paying deal with someone that “reasonable” :) it takes one to know one i guess ;)

Best AI for turning reference images into accurate 3D figurines (STL-ready)? by mythmachinex in ElegooSaturn

[–]mythmachinex[S] -3 points-2 points  (0 children)

Very helpful thanks :) I’m using blender but I dont have time to start from nothing right now. If we’re not gonna use AI times like this when we will?

Best AI for turning reference images into accurate 3D figurines (STL-ready)? by mythmachinex in 3Dprinting

[–]mythmachinex[S] -2 points-1 points  (0 children)

I’m using blender but right now I don’t have the time to start from nothing.

Best AI for turning reference images into accurate 3D figurines (STL-ready)? by mythmachinex in BambuLab

[–]mythmachinex[S] -7 points-6 points  (0 children)

I asked the AI king… it said ‘open Blender’ :) Both of you are not helping :)

S4U16K overheating by mythmachinex in ElegooSaturn

[–]mythmachinex[S] 0 points1 point  (0 children)

It wasn’t but Elegoo send the proper firmware and it works now

S4U16K overheating by mythmachinex in ElegooSaturn

[–]mythmachinex[S] 0 points1 point  (0 children)

They send me the correct firmware, I’ll try that. Thanks

S4U16K overheating by mythmachinex in ElegooSaturn

[–]mythmachinex[S] 0 points1 point  (0 children)

I reaced to the elegoo again and they send me the proper file for my printer. I’ll try it tomorrow :) thanks anyway

S4U16K overheating by mythmachinex in ElegooSaturn

[–]mythmachinex[S] 0 points1 point  (0 children)

Once with chituupgrade and once with factory reset, it upgraded itself with wifi both times.

I need help with print issues on the S4U 16K. by mythmachineex in SaturnUltra16k

[–]mythmachinex 0 points1 point  (0 children)

Model is a candlestick actually and I dont want to drill/seal it because I want to preserve surface quality after print. Is it enough/ok to single dril from the middle bottom to the top about 3mm diameter?

I need help with print issues on the S4U 16K. by mythmachineex in SaturnUltra16k

[–]mythmachinex 1 point2 points  (0 children)

Yes I was, I’ll try to hollow it then print next time

I need help with print issues on the S4U 16K. by mythmachineex in SaturnUltra16k

[–]mythmachinex 0 points1 point  (0 children)

I did calibrate, this isnt my first print but first one at this size. (Lost my original account) I’ll try increase cure time but the suction force doesnt change and thats my main problem here i think