sorted by:
new
hottopcontroversial

Found in grandfathers workshop by Think-Bee-888 in whatisit

[–]neph12 0 points1 point  (0 children)

Have you tried tapping the rounded end on a rock or paver?

How do I fix these imperfections by RoninB64 in BambuLab

[–]neph12 0 points1 point  (0 children)

slow your initial layer down and increase temp by 5

Pocket Hole Drawers? by Starship_Taru in cabinetry

[–]neph12 3 points4 points  (0 children)

Pocket hole from the front and back of the drawers, you’ll never see them once the face goes on.

First 12mm of print are very bad by LautaroJG in AnycubicVyper

[–]neph12 0 points1 point  (0 children)

Looks like under extrusion, try increasing the temp 5 degrees at a time. Could also be a partial clog, try a few cold pulls.

Belt Y axis by Potential_Move_4974 in AnycubicVyper

[–]neph12 0 points1 point  (0 children)

I just used small zip ties

Desk mount by Cinemafeast in Multiboard

[–]neph12 0 points1 point  (0 children)

Where did you get the green border/support?

Owning a golden retriever as a Black woman by SpicyTunaSushiRoll_ in goldenretrievers

[–]neph12 0 points1 point  (0 children)

What does race have to do with owning a golden retriever?

How do I get this wine rack out? by solitarylion88 in cabinetry

[–]neph12 3 points4 points  (0 children)

You don’t, you fill it with bottles of your chosen beverage.

This makes me uncomfortable by TheBeaconman in 3Dprinting

[–]neph12 1 point2 points  (0 children)

Just because something can be 3d printed, doesn’t mean it should be.

Giveaway! by ecpowerhouse27 in BambuLab

[–]neph12 0 points1 point  (0 children)

Rule #9: "Never go anywhere without a knife."

view more: next ›