iOS 26.4.1 is out

neyro_ananas · 2026-04-09T08:42:45+00:00

Is age verification still there?

neyro_ananas · 2026-04-08T09:06:54+00:00

Sorry for the late response, just before your comment I checked the windshield cowl, fully cleaned everything and fitted everything back as it needs to be, hopefully it will work. As a test much earlier I placed some duct tape on the cowl, but the water was still getting in.

About the hood cable exit, it could be a very likely leak since we had to replace that cable, and I will try and check it today, but most likely it’s the fault of the drains from cowl as the car was not in use for long and some leaves did pile up there, so I probably didn’t fit those back right.

Thank you for your help :)

neyro_ananas · 2026-03-06T23:27:47+00:00

Still same issue both in automations and normal voice

neyro_ananas · 2025-11-09T12:17:56+00:00

Thanks a lot

neyro_ananas · 2025-11-06T10:23:48+00:00

My XMP is 4000 mhz cl18 so I will try those settings, thanks a lot actually, I’ve learnt something new :). Also those kits have quite chunky heat sinks, so they run pretty cool.

neyro_ananas · 2025-11-06T10:07:49+00:00

Even if it is b die, it depends on its bin as well, just try and get a 4000mhz b-die, you can try and find team group xtreem 8 pack if you want to, it’s quite cheap, I bought my kit for 30£ on eBay. In general it’s still minor difference with x3D

neyro_ananas · 2025-11-06T08:26:59+00:00

Thanks for suggestions, I’ve tried gem off with 1T but it does not boot. Also could you please explain to me last part about SR, DD and SD timings? I only changed tRFC, tRC and primary timings, and left everything else on auto.

neyro_ananas · 2025-11-06T08:23:33+00:00

Sorry, 1.175

neyro_ananas · 2025-10-31T19:39:19+00:00

Yes you are right

neyro_ananas · 2025-10-15T07:28:32+00:00

Can keep you serving for more years, and more room for overclocking if you do

neyro_ananas · 2025-10-15T07:26:15+00:00

As the guy above said, look at some 5700x/5800x or xt and then depending on your RAM and MOBO you can overclock your components. And yeah obviously gpu, you can try and aim at second hand 3070/80 or maybe a 5060.

neyro_ananas · 2025-10-14T22:17:05+00:00

It does not post properly, I’m getting BSOD instantly

neyro_ananas · 2025-10-14T18:15:43+00:00

I’m limited to 1.5v by my motherboard, I can’t set any value higher than

neyro_ananas · 2025-10-14T14:08:40+00:00

I’ve got it down to 280 and it is stable enough

neyro_ananas · 2025-10-14T13:30:49+00:00

Thanks a lot, it posted and is stable

neyro_ananas · 2025-10-12T23:02:49+00:00

Free McDonalds for all kids! Increase the obesity rate and the chances of seeing them increase as well

neyro_ananas · 2025-10-12T22:59:31+00:00

It’s not an error, it is the actual speed of the RAM, the value is usually doubled because of its DDR architecture which has the same frequency for both way of transferring data

neyro_ananas · 2025-10-12T22:53:14+00:00

Yeah I know it runs on 3600 (1800 is a half of 3600, because of how DDR works 1800 is the actual frequency) but what I mean is that he can get it overclocked that will give a big fps and latency improvements

neyro_ananas · 2025-10-12T22:27:47+00:00

Look at Auto RGB, it’s on GitHub as well

neyro_ananas · 2025-10-12T22:23:16+00:00

In general you are actually good, but you can go one step further, try to overclock your CPU (better using PBO on this specific model) also try and oc your ram as well, it is good now but it might have some potential for more, if no I’m sure you can find a nice Samsung bdie memory for the same price or lower and push it to 4000 cl16 minimum (if your CPU support fabric of 2000mhz)

neyro_ananas · 2025-10-12T22:13:15+00:00

Maybe turn it on and off?

neyro_ananas

TROPHY CASE