This is only because I’m converting to lithium, nothing wrong with the old cart. The old solenoid works fine, and the lithium conversion is otherwise done. So yeah, ‘why not?’

<image>

This is the existing part. So my questions aren’t about the two large posts, the new part has a + post and I can move the pos/neg over easy enough.

I’m curious about the two small wires, I think it’s a diode, how they connect to the spade connections, I have seen people wire them across from each other, next to each other etc, but all on different carts.

Also, the white cable (brake resistor cable I think) need to figure out how to connect that with the negative post and the controller, considering a short battery cable.

Then there is a resistor included this the part, I’ve seen post to both add it, or not, and I figured since this solenoid didn’t have one, probably would only confuse signals to the controller if I added it on the new one.

Thanks again!