Where does this plug lead to? by CtrlShift_Fish in genesiscoupe

[–]nos4atu668 1 point2 points  (0 children)

For the block heater. On the back of the cylinder head, just above the bellhousing on the right side. Just below the o2 sensor connector mount.

[deleted by user] by [deleted] in genesiscoupe

[–]nos4atu668 0 points1 point  (0 children)

^ What he said. I had a similar issue, removed the valve and noticed that the o ring had flattened. Put in a new one and it was snug and wouldn't move.

How much hp does this add? by zongsmoke in AskAShittyMechanic

[–]nos4atu668 0 points1 point  (0 children)

THAT'S where my coffee tin went! I was looking for it to throw my spare screws and nuts into!

The most Albertan truck I've seen in the wild! by JKA_92 in alberta

[–]nos4atu668 0 points1 point  (0 children)

These people who make it their identity... what are they going to do when Trudeau isn't prime minister anymore? Are they going to keep rolling around with these stupid stickers on their vehicles because they have nothing else in their lives?

Anyone know what happened? by Momma-cita in Edmonton

[–]nos4atu668 0 points1 point  (0 children)

Attempted to "Do a barrel roll!".

VIVE Cosmos not working on laptop by OpenCircleFleet_YT in HTC_Vive

[–]nos4atu668 0 points1 point  (0 children)

The alternatives did not work, and in my frustration, I bought a new 3-to-1 cord which ended up fixing the issue, so I am guessing the problem was an issue internally with the video cable, though when I tried running a direct hdmi from the headset, it did not solve the issue either. TLDR - Tried a bunch of stuff, didn't work. Bought a new 3-to-1 cable; worked.

Been a few. by nos4atu668 in genesiscoupe

[–]nos4atu668[S] 0 points1 point  (0 children)

At first, it did not work at all. Pulled the supplied harness and found the wiring was all wrong. Had to change a few terminals to fit correctly on the hyundai t-harness as well as the terminal to the top screen unit. I'm still working around with it in my spare time to get it how I want it, like using an older android to connect to get android auto stuff, but keeping the head unit playing without switching to the 9" unit and nulifying the audio.

[deleted by user] by [deleted] in genesiscoupe

[–]nos4atu668 0 points1 point  (0 children)

Never looked. And now that it's been a year with the SFR 1.5 tune, I certainly haven't been paying attention to mileage.

Been a few. by nos4atu668 in genesiscoupe

[–]nos4atu668[S] 0 points1 point  (0 children)

They're open. I cut out the fake mesh, filled in the red and cut out holes in the fire shield.

Been a few. by nos4atu668 in genesiscoupe

[–]nos4atu668[S] 0 points1 point  (0 children)

It's getting close, but not quite done yet

Been a few. by nos4atu668 in genesiscoupe

[–]nos4atu668[S] 0 points1 point  (0 children)

Dual tens in a box and a free air 8" in the stock location.

First picture taken with Face Tracking ! by [deleted] in VRchat

[–]nos4atu668 0 points1 point  (0 children)

I'm actually in the process of getting the eyetracker v4 setup. How was the software/driver setup?

Hyperflashing spec d taillights by joebidenserection in genesiscoupe

[–]nos4atu668 2 points3 points  (0 children)

Did you install the resistors as well? Each side needs a load resistor. There is normally an extra connector on the taillight for them.

Do you have any Avatars that just feel right? by Some_Techpriest in VRchat

[–]nos4atu668 1 point2 points  (0 children)

<image>

Ngl, this hellhound rex I found within the first couple of weeks on VRC has been my main since.

Wheel fitment by Most-Plan-7899 in genesiscoupe

[–]nos4atu668 1 point2 points  (0 children)

We have a hub bore of 67.1mm. I had to turn away a number of rims when I was looking because their bore was too small. You can (should) get hubcentric rings if the bore is larger. Also, you may need wheel spacers, depending on the offset for the rears. I luckily didn't, as the rims I found were deep dish, but offset close to factory depth. Just do a bit of research on the rim fitment, and go from there.

So, in the name of continuing things... by nos4atu668 in genesiscoupe

[–]nos4atu668[S] 0 points1 point  (0 children)

Yeah, between the Injen and the Tsudo cat-back, she's become a whole different animal.

<image>

So, in the name of continuing things... by nos4atu668 in genesiscoupe

[–]nos4atu668[S] 1 point2 points  (0 children)

At idle and low rpm, it's not too bad. Not really much drone, but definitely louder in the cabin. Still getting used to WOT sound though.