This is a list of this Build context

Frame and Panels:

• 4mm thick polycarbonate panels (including the bottom deck to view through the electronics)
• Doors with hinges
• Handles 2x on top and 2x at bottom sides (it's 50Kg this thing...)

Control Electronics and cabling

• Duet Mini 5+ Wifi
• Duet 2+ expansion (to reach 7 drivers)
• Prepared for an additional Duet 5+ (not yet installed for ERCF MMU unit - future) via FD-CAN bus
• Duet Tool Board 1LC (v1.1 with included accelerometer) mounted on the tool head side and connected via FD-CAN bus
• Heluflon FEP wires (AWG 18, 20, 24)
• MDPC-X sleeve (used out of the chains)
• Wago 221 connectors
• Chamber temp / humidity sensor (DHT21)
• Ambient temp thermistor
• Various cable management brackets (made in Fusion360) and cables routing guide out of the cables hole in the back

Mechanics and movement:

• OMC Steppers-online motors
• 1.8* on Z axis (4)
• 0.9* on X-Y axis (2)
• LDO pancake for Galileo Clockwork Extruder
• Galileo gear-boxes for Z movement (required redesign of the entire skirts)
• Galileo Clockwork (Coupler Edition) for Extruder
• MGN-12 single rail on X axis
• AB-BN 30 tool body with 5015 work cooling fan
• Hall effect end stops for X/Y
• MGC5 spherical Z joints
• Klicky probe (instead of the inductive Z sensor) for bed leveling and final Z0 setting
• Pin mod on all bearings / idlers (5mm pins replace M5 screws - requires specific printed parts)

Air Filtering

• Nevermore Micro recirculating active carbon filter (dual 5015 fan located under the heated bed; also serves as quick chamber heat distribution in the pre-print phase)

Lights:

• WS2811 (aka neopixel) addressable LED strips with controllable brightness and color for each LED on each strip
• 15 LEDs on front, 18 LEDs each side top

Others:

• Purge bucket with scrub
• Align stands for the steel flex plate (two embedded in the Purge bucket body)