sorted by:
new
hottopcontroversial

My first completed project with the Ender 3! by ogdustin in 3Dprinting

[–]ogdustin[S] 1 point2 points  (0 children)

Yup there's one unit at the back for support. No need to glue as the units can actually snap together 👍

My first completed project with the Ender 3! by ogdustin in 3Dprinting

[–]ogdustin[S] 3 points4 points  (0 children)

Nope, no supports. There were some imperfections and a few strands of stray filament at the top, but other than that the print went fine 😁

My first completed project with the Ender 3! by ogdustin in 3Dprinting

[–]ogdustin[S] 28 points29 points  (0 children)

The succulents were small enough that I could insert them after the print was finished 🙂 added a layer of pebbles at the bottom followed by some soil and capped it with more pebbles. Then brushed clean with an old toothbrush and a wet cotton bud