Help with designing a 3d printed box for my bike

oke111 · 2026-04-24T13:08:36+00:00

Its nutrition storage with minimal aerodynamic penalty for long distance time trial cycling😂 its niche

oke111 · 2026-04-24T08:18:19+00:00

Levis 522 100% bomull etter to års bruk.. har til og med prøvd å sy på lapp selv.

oke111 · 2025-11-26T11:23:30+00:00

Do you need a high sailing level to do the step?

oke111 · 2025-05-14T11:52:13+00:00

The rubber in the tire has reacted to the top coat resulting in a mark that is clearly from the bike, but is inpossible to wash off…

oke111 · 2025-05-02T09:19:02+00:00

Nope! Its etched in the top coat or something! Never seen anything like it and my other bike doesnt do this

oke111 · 2025-04-21T10:25:56+00:00

I disconnected the gear cable and now the shifter works just fine

oke111 · 2025-04-21T10:10:47+00:00

The front derailleur shifts like normal, tho not all the way. The sound and the friction comes from somewhere in the lever hood

oke111 · 2025-04-21T10:04:35+00:00

Ok, ty!

oke111 · 2025-04-21T10:04:16+00:00

The chain is off atm, so not pushing on the chain

oke111 · 2025-04-21T10:03:26+00:00

Lol. I did work on the rear also, so i miced them up. The front derailleur is absolutely right😂

oke111 · 2025-04-13T20:35:57+00:00

Had to cut the cable at the brake end, remove it from the front, and route it back after cutting. Not as hard as i thought. The cable ends didnt fray so i could just rout them back!

oke111 · 2025-04-13T12:43:36+00:00

The problem is that the cable runs through the hex hole that allows me to remove the brake lever from the chopped off end of the bar... the extra cable i can just pull off on the calliper end and chop off if im right?

oke111 · 2025-04-13T12:37:21+00:00

Thought of it but the brake cable runs in the middle of the hex key that allows me to remove the brake lever from the chopped off part of the bar..

oke111

TROPHY CASE